User manual RYOBI 725R-41CD725A034

[. . . ] This operator's manual provides you with easy-to-understand operating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. The other manual that came with your power tool, the parts manual, contains all the information that you need to order parts. I. II. TABLE OF CONTENTS California Emission Regulations . [. . . ] 7 Knob For edging when using the line head cutting attachment with Click-Link® models, lock the release button of the cutting attachment into the 90° edging hole or the 180° edging hole (Fig. The edger add-on should be installed with the release button in the primary hole. 12 OPERATING INSTRUCTIONS HOLDING THE TRIMMER WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury when operating this unit. Before operating the unit, stand in the operating position (Fig. Check for the following: · The operator is wearing eye protection and proper clothing. · The right arm is slightly bent, and the hand is holding the shaft grip. · The left arm is straight, and the hand is holding the handle. · The cutting attachment is parallel to the ground and easily contacts the vegetation to be cut without the operator having to bend over. Each time the head is bumped, about 1 inch (25. 4 mm. ) of trimming line is released. A blade in the cutting attachment shield will cut the line to the proper length if excess line is released. For best results, tap the Bump HeadTM on bare ground or hard soil. If line release is attempted in tall grass, the engine may stall. Always keep the trimming line fully extended. 12). HOLDING THE UNIT WITH EDGER ADD-ON WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury when operating this unit. Before operating the unit, stand in the operating position (Figs. Check for the following: · The operator is wearing eye protection and proper clothing. · The right arm is slightly bent, and the hand is holding the shaft grip. · The left arm is straight, and the hand is holding the handle. · The edger wheel adjusted for proper cut depth and edger positioned as shown in Fig. 13 14 OPERATING INSTRUCTIONS ADJUSTING EDGER CUTTING DEPTH 1. Loosen the adjustment knob above the wheel (Fig 14). Slide the wheel to the desired position. · Raising the wheel increases the cutting depth. · Lowering the wheel decreases the cutting depth. Tighten the adjustment knob securely. HANGER A plastic hanger (Fig. [. . . ] · You are responsible for presenting your small off-road engine to a Ryobi Authorized Service Center as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If you have any questions regarding your warranty rights and responsibilities, you should call 1-800-345-8746. 27 LIMITED TWO-YEAR WARRANTY RYOBI OUTDOOR PRODUCTS warrants each new RYOBI Product for two (2) years according to the following terms. This warranty extends to the original retail purchaser only and commences on the date of original retail purchase. [. . . ]