User manual RYOBI 725R-SERIALS-611000001-AND-UP

[. . . ] 0o - 90o Blade Size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 x 22 x 4 mm Biscuit Size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . #0, #10, #20 Net Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2. 65 kg DOUBLE INSULATED N197 THANK YOU FOR BUYING A RYOBI BISCUIT JOINER Your new Biscuit Joner has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation and operator safety. [. . . ] DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF. Have defective switches replaced by authorised service centre. DO NOT OPERATE THIS TOOL WHILE UNDER THE INFLUENCE OF DRUGS, ALCOHOL OR ANY MEDICATION. THE APPLIANCE IS NOT INTENDED FOR USE BY YOUNG OR INFIRM PERSONS WITHOUT SUPERVISION. YOUNG CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH THE APPLIANCE. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE Due to continued product refinement policy, product features and specifications can and will change without notice. Check current features and specifications with your retailer. Page 1 FEATURES 2 1 8 4 3 5 9 7 6 12 10 11 1. Motor Housing Page 2 APPLICATIONS Use your biscuit joiner only for the purposes listed below: Cutting and jointing of timber Edge jointing long boards of either natural wood or manufactured sheeting ADJUSTMENTS The adjustable fence will cut joints at angles from 0 to 90 at a fixed cut height of 9mm (5/16") (the center of a 25. 4mm board). To utilize the adjustable fence (4), remove the fixed fence by loosening the height lock knob and rotating the height adjustment knob until the fixed fence comes clear of the top of the joiner fence. Loosen the angle lock knob (11) and move the adjustable fence to the desired angle and re-tighten the knob. When using the adjustable fence for 90 degree cuts. it is recommended that you verify the angle of cut with a measuring tool such as a combination square or other device. 6~7) Position your work pieces together and draw a reference mark at 90o to the center point of each proposed joint location. Separate your work material and clamp each piece securely to a stable work bench or work table. Set the biscuit depth selector (6) to correspond with the size of biscuit you are using. Generally #20 biscuits suit most applications. If you are using stock that is 16mm thick or less, you will need smaller biscuits. Adjust the height of the fence as required and if using the fixed fence firmly tighten height lock knob (5) using finger pressure only. If using the adjustable fence firmly tighten angle lock knob (11). Place one hand on the handle (2) and the other hand on the motor housing (12). Place the cutting guide at the center point of each slot in turn and press the fence against the edge of the work piece (see figure 6). Make sure the jointer fence is flush to both sides of your work surface. Switch on the power switch and push the motor housing towards the work material. [. . . ] Remove the fixed fence and raise the adjustable fence to the o degree position. Turn the machine over and unscrew the two screws in the base plate. 8) Now, with the arbor lock (8) in the top of the gearbox housing depressed, rotate the blade by hand until the blade locks. Loosen the blade flange anti-clockwise using the pin wrench supplied. (see Fig. [. . . ]