User manual RYOBI 750R-SERIALS-602000001-THRU-

[. . . ] Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. [. . . ] A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. POWER TOOL USE AND CARE Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by young children or infirm persons. Adequate supervision by a responsible person must be provided to ensure that they do not play with the appliance. Visitors should wear 2 OPERATION APPLICATIONS (Use only for the purposes listed below. ) Drilling wood, materials and resin boards. Drilling concrete (impact drilling only). Drilling metal: steel, brass, aluminum sheets, stainless steel & pipe. SWITCH See Figure 1 & 3. This tool can be started and stopped by squeezing and releasing the trigger switch (1). The speed can be adjusted by controlling the force applied to the trigger. The maximum speed of the drill may be set at different speeds by adjusting the variable speed selector (4). For continuous operation, press the lock-on button (5) while squeezing the trigger. Squeeze the trigger again to release the lock. CHANGING THE ROTATION DIRECTION See Figure 2. To change the direction of rotation, stop the tool and push the forward / reverse selector (2). [. . . ] This warns the user that the tool is connected and will operate when the switch is pressed. OPERATING NEVER COVER THE AIR VENTS (10) SINCE THEY MUST ALWAYS BE OPEN FOR PROPER MOTOR COOLING. MAINTENANCE After use, check the tool to make sure that it is in good condition. It is recommended that you take this tool to a RYOBI Authorised Service Center for a thorough cleaning and lubrication at least once a year. DO NOT MAKE ANY ADJUSTMENTS WHILE THE MOTOR IS IN MOTION. ALWAYS DISCONNECT THE POWER CORD FROM THE POWER SUPPLY BEFORE CHANGING REMOVABLE OR CONSUMABLE PARTS (BLADE, BIT, ETC. ), LUBRICATING OR WORKING ON THE UNIT. [. . . ]