User manual RYOBI 764R-SERIALS-203096321-THRU

[. . . ] Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating power tools in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. English hands of untrained users. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. The maximum speed of the drill may be set at different speeds by adjusting the variable speed selector. For continuous operation, press the lock-on button while squeezing the trigger. Squeeze the trigger again to release the lock. CHANGING THE ROTATION DIRECTION See Figure 2. To change the direction of rotation, stop the tool and push the forward / reverse selector. When the forward selector is pushed in, the bit rotates clockwise when viewed from the handle end of the tool. English When the reverse selector is pushed in, the bit rotates counterclockwise. MOUNTING AND REMOVING THE BIT See Figure 4. Insert the drill bit into the chuck as far as the plain part of its shank will go. Tighten the chuck securely by rotating the chuck head in a clockwise direction. The bit can be removed by rotating the chuck in a counterclockwise direction. CHANGING BETWEEN DRILLING AND IMPACT DRILLING MODE See Figure 5. [. . . ] AUXILIARY HANDLE AND DEPTH GAUGE See Figure 6. " and " BIT STORAGE See Figure 7. The auxiliary handle also contains a compartment to store drill bits. To access this compartment unscrew the end cap below the grey trim on the handle in an anticlockwise direction. [. . . ]