User manual RYOBI 765R

[. . . ] 8 24 EBW4023L 39 ATTENTION LASER RAYS DO NOT LOOK DIRECTLY INTO THE BEAM Laser Specification EN60875-1: 1994+ Laser class 2 A11: 1996+A2:2001 Wave lengths: 650 nm Output Power: <1mW 33 24 15 35 38 34 36 37 Fig. 10 37 24 38 35 39 38 40 37 39 41 Fig. 12 EBW4023L ATTENTION LASER RAYS DO NOT LOOK DIRECTLY INTO THE BEAM Laser Specification EN60875-1: 1994+ A11: 1996+A2:2001 Laser class 2 14 Wave lengths: 650 nm Output Power: <1mW 4 6 42 Fig. 14 EBW4023L 57 ATTENTION LASER RAYS DO NOT LOOK DIRECTLY INTO THE BEAM EBW4023L ATTENTION LASER RAYS DO NOT LOOK DIRECTLY INTO THE BEAM Laser Specification EN60875-1: 1994+ Laser class 2 A11: 1996+A2:2001 Wave lengths: 650 nm Output Power: <1mW Laser Specification EN60875-1: 1994+ Laser class 2 A11: 1996+A2:2001 Wave lengths: 650 nm Output Power: <1mW 43 44 55 45 Fig. [. . . ] NOTE: Adjust blade tension properly before making tracking adjustments. Check that the blade guides are not interfering with the blade. WARNING: To Adjust: If the blade has moved left or right of centre: Open the front cover by releasing the upper and lower latches. Watch the blade's position on the upper tire through the tracking view window (18) as, by hand, you slowly turn the upper wheel clockwise. If the blade moves away from the centre of the tire, the tracking must be adjusted. Page 10 Turn the blade tracking knob (10) (clockwise if blade has moved left and counterclockwise if blade has moved right) while turning the wheel by hand until the blade moves back and rides in the centre of the tire. Check the position of the blade on the lower tire. The blade should be completely on the tire. If not, adjust the tracking until the blade is on both tires. ADJUSTMENTS Rotate the upper wheel by hand in a clockwise direction for a few more turns. Make sure the blade stays in the same location on the tires. Readjust, if necessary, until blade is tracking properly. NOTE: A 3 mm (1/8") blade may not track properly in the center of the wheel. It may be better to track this blade on the back half of the upper wheel. Check squareness of the saw table to the blade. Loosen screw on scale indicator with a phillips screwdriver and align scale indicator to zero. Replace the blade guard once the saw table has been squared. Remove the blade guard by loosening the two set screws with 4mm hex key. Adjust the position of the blade guide assembly. Loosen the bottom screw on the right side of the blade guide assembly using the 4 mm hex key. Slide the upper blade guide support on the shaft until the front edge of the blade guides are about 0. 4 mm (1/64") behind the gullet of the blade. Repeat this procedure for the lower blade guide support. Replace the blade guard if no additional adjustments are to be made. NOTE: The lower blade guide support screw (37) is the top screw located on the right of the saw housing under the table (Fig. 11). Adjust Blade Guide Support: Never operate saw without blade guard secured in place. T do so could result in possible serious personal injury. [. . . ] There is a brush (46) located inside the saw housing, next to the lower wheel ( 29). It helps to protect the tire (47) and wheel by brushing off saw dust. As the brush becomes worn out, it will need to be adjusted or replaced. Remove the screw (48) and washer (20), then pull the brush (46) off. [. . . ]