User manual RYOBI 780R-SERIALS-001031001-THRU-102066940

[. . . ] If you use your cordless impact driver properly and only for what it is intended, you will enjoy years of safe, reliable service. Thank you again for buying Ryobi tools. SAVE THIS MANUAL FOR FUTURE REFERENCE 1 6 4 3 2 1 1 5 2 (Y) 25 3 20 M8 x 12 3 15 4 10 M6 x 10 5 0. 5 1. 0 (X) 4 Page 1 5 THANK YOU FOR BUYING A RYOBI PRODUCT. To ensure your safety and satisfaction, carefully read through this OWNER'S MANUAL and the SAFETY INSTRUCTIONS before using the product. SPECIFICATIONS Bit shank size Driving capacity Max. fastening torque Voltage Battery type No load speed Overall length Net weight Charging time Charger rating 1/4" (6. 35 mm) DESCRIPTION 1. LED INSTRUCTIONS FOR SAFE HANDLING 1. [. . . ] Do not operate tool when you are tired. MOUNTING AND REMOVING THE BIT (Figs. Slide the sleeve of the bit holder (1) forward. Insert the bit (2) into the bit holder as far as it will go. Confirm that the bit is secured by pulling it forward. The sizes of the bits which can be used for this tool are A = 16 mm and B = 13 mm. Use a bit that matches the screw or bolt to be driven. Do not use a damaged bit. SWITCH (Fig. 3) This tool is started and stopped by squeezing and releasing the trigger (3). The rotation speed is variable from 0 through 2300 min-1 by controlling the trigger-squeezing force. CHANGING THE ROTATION DIRECTION (Fig. 4) To change the rotation direction, stop the tool and push the reversing switch (4) to the opposite side. When the reversing switch is pushed in from the side of "R", the bit rotates clockwise when viewed from the handle end of the tool. Therefore, you should charge it prior to use. NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (cutting followed by recharging) for them to fully charge. Charge battery pack only with the charger provided. Make sure power supply is normal house voltage, 240 Volts, 50 Hz, AC only. Align reaised rib on batery pack with groove in charger. Press down on battery pack to be sure contacts on the battery pack engage properly with contacts in charger. When properly connected, red light will turn on. Normally, the yellow and green lights on the charger will come on. This indicates charger is in control charge mode and should switch to fast charge mode within 5 minutes. When charger is in fast charge mode the red light will come on. [. . . ] 1. Do not touch the terminals with any conductive materials. 2. Avoid storing the battery in a container with other metal objects such as nails, coins, etc. 3. Do not expose the battery to water or rain. Do not store the tool and battery in locations where the temperature may reach or exceed 50°C. Page 3 OPERATING GREEN LIGHT "ON" INDICATES FULLY CHARGED BATTERY CHARGER NEVER COVER THE AIR VENTS SINCE THEY MUST ALWAYS BE OPEN FOR PROPER MOTOR COOLING. [. . . ]