User manual RYOBI 780RB-SERIALS-203096321-THRU-

[. . . ] Battery charging in closed cupboards, near heat sources (radiators, bright sunshine) etc. causes heat to accumulate and can damage the device. If the battery is not going to be used for a long period, pull the battery off the battery charger and pull out the mains plug. Protect battery contacts from metallic objects to avoid a short circuit which could result in a fire or explosion! [. . . ] Screws should be installed so that the center distance is 381mm. n Install screws to securely attach bracket. n Place bottom end of charger into the bracket then snap the top of charger securely into the bracket. n Charger should fit snugly and securely in the bracket. 1 English SPECIFICATIONS Battery Pack Voltage Charger Input Battery Capacity No. of cell for battery 15 BATTERY PROTECTION FEATURES Ryobi One+ 18 V Lithium-Ion batteries are designed with features that protect the Lithium-Ion cells and maximise battery life. If the tool stops during use, release the trigger to reset and resume operation. If the tool still does not work, the battery needs to be recharged. NOTE: The LED charge indicator light will not work if the battery protection feature has caused the battery pack to stop powering the tool. When the battery pack resets itself, the LED will again function. 130247015 18 V 220-240V, 50-60Hz, AC only 220-240V, 50-60Hz, AC only 220-240V, 50-60Hz, AC only 1. 7 Ah BPL-1820 18 V 2. 4 Ah 10 BPL-1815 18 V 1. 4 Ah 5 CHARGING THE BATTERY PACK Use only Ryobi One+ 18V battery packs with this charger. Battery packs for this tool are shipped in a low charge condition to prevent possible problems. Therefore, you should charge them until the green LED on the front of the charger comes on. Note: The charger and battery pack should be placed in a location where the temperature is more than 10°C but less than 38°C. n When batteries become fully charged, it is suggested to unplug the charger from the power supply and remove the battery pack. n To remove the battery pack from the charger, depress the latches on each side of the battery pack. CHARGING A HOT BATTERY PACK When using a tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. Note: This situation only occurs when continuous use of a tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to "CHARGING A COOL BATTERY PACK" for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorised Service Center for electrical check. LED FUNCTIONS OF CHARGER See Fig. 4. LED FUNCTIONS BATTERY PACK RED LED Power Without battery pack ON Evaluate Hot battery pack Cold battery pack Deeply discharged Flashing Flashing Flashing Defective Defective Flashing Flashing Battery pack or charger is defective. OFF OFF OFF When battery pack reaches cooled temperature, charger begins fast charge mode. [. . . ] It is not recommended to leave it in a cold works van overnight. Ensure no metal filings or swarf can fall into the vents during storage, as this may cause serious injury when it is next used. LED shows a slow pulse - batteries are in maintenance mode. 100% 0% WAVE PULSE LED produces fluctuating pulse ­ charger is in energy save mode. Batteries are neither charging or being maintained. n When batteries are charging, the blue LED status button will maintain a full and constant brightness. [. . . ]