User manual RYOBI 790R-SERIALS-407104738-THRU-

[. . . ] READ ALL INSTRUCTIONS KNOW YOUR POWER TOOL. Read the operator's manual carefully. Learn the applications and limitations as well as specific potential hazards related to this tool. GUARD AGAINST ELECTRICAL SHOCK by preventing body contact with grounded surfaces. [. . . ] Before turning on, ensure belt guard is down and the chuck is installed correctly. Remove adjusting keys and wrenches before turning on power Ensure the chuck key is removed from the chuck before turning on the power. Ensure the drill bit is securely locked in the chuck using the key supplied. Use recommended speed for drill bit size and workpiece material. Keep belt guard in place while machine is in operation. Disconnect tool before changing drill bit and ensure switch is in the off position before plugging in. Do not use bench drill in damp or wet conditions. Adjust the table or depth stop to avoid drilling into the table. RISK OF INJURY DUE TO ACCIDENTAL STARTING. Do not use in an area where children may be present. DO NOT OPERATE THIS TOOL WHILE UNDER THE INFLUENCE OF DRUGS, ALCOHOL, OR ANY MEDICATION. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. WARNING: Page 4 RULES FOR SAFE OPERATION LASER LIGHT. Only turn laser beam on when tool is on work piece. Class 2 laser product CAUTION: Use of controls or adjustments or performace of procedures other than those specified herein may result in hazardous radiation exposure. Laser type: Semiconductor Laser class: 2 Wave length: 650NM Power supply: 3V Laser power: < 1 mW For service personnel. CAUTION: Avoid exposure to beam when servicing. Complies with AS2211. 1. 1997 as a Class 2 Laser. Warning: Do not stare directly at the laser beam. A hazard may exist if you deliberately stare into the beam, please observe all safety rules as follows. The laser shall be used and maintained in accordance with the manufacturer's instructions. Never aim the beam at any person or an object other than the workpiece. The laser beam shall not be deliberately aimed at personnel and shall be prevented from being directed towards the eye of a person for longer than 0. 25s. Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces, i. e. wood or rough coated surfaces are acceptable. [. . . ] Tighten shifter bar. Fig. 6 Fig. 3 Belt Tension Adjustment (Fig 7) To gauge proper belt tension, use pressure to push down with the thumb. Your thumb should be located on the belt midway between the two pulleys. Mark a cross as the target location to be drilled on the workpiece. Press the on/off to switch on the laser beam and let the laser line on the workpiece. [. . . ]