User manual RYOBI 852R-SERIALS-905410755-THRU-

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. damaged or entangled cords increase the risk of electric shock. When operating a power tool outdoors, use an extension cord suitable for outdoor use. [. . . ] Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. Do not use the power tool if the switch does not turn it on and off. Any power tool that can not be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. Check for misalignment or bindling of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. The use of attachments or accessories not recommended can result in serious personal injury. Always wear safety glasses with side shields. Everyday glasses have only impact resistant lenses. Following this rule will reduce the risk of eye injury. You may use this stapler for the purpose listed below: Test on a scrap piece of the same material you are using to achieve the desired depth. Align raised rib on battery pack with groove inside stapler. Make sure the latches on each side of the battery pack snap in place and battery pack is secured in stapler before beginning operation. CAUTION When placing battery pack in the stapler, be sure raised rib on battery pack aligns with the bottom of the stapler and latches into place properly. Press the activation foot of the stapler down against the workpiece. The activation foot must be depressed before the switch trigger is depressed. NOTE: The stapler will drive another staple each time the trigger is depressed as long as the activation foot is depressed. [. . . ] Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. Chemicals can damage, weaken ordestroy plastic which may result in serious personal injury. [. . . ]