User manual RYOBI 960R-SERIALS-411088141-THRU-

[. . . ] Your saw is equipped with a lock-on feature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your saw will continue running. To release the lock, depress the switch trigger and release. [. . . ] Once the desired angle is reached, slide the base back until the tab on the motor housing aligns with the appropriate notch on the rear of the base. Position the holder for the roller guide in such a manner that the guide roller faces against the back of the saw blade. Precise cuts are possible only when the guide roller faces tightly against the back of the saw blade. To avoid possible serious injury, always wear safety goggles or safety glasses with side shields. Keep hands and ¿ngers away, from the motor housing and blade clamp and do not reach underneath work while blade is cutting. To avoid serious personal injury, do not use saw without safety guard properly in place. Rest the front of the saw base on the workpiece and align cutting edge of the blade with the line on your workpiece. Make sure the power cord is out of the way of saw blade and not in the line of cut. Start your saw and move it forward on the work surface. Apply downward pressure to keep the saw steady and only enough forward pressure to keep the blade cutting. To avoid loss of control, broken blades, or damage to the material being cut, always use extreme caution when making plunge cuts. Adjust edge guide to the desired width and lock in place with the edge guide screw. When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. When cutting metal, keep exposed portion of saw bar clean and free of metal chips by wiping frequently with an oily cloth. Use extreme caution in disposing of oily cloth after completion of job to prevent potential ¿re hazard. With the air jet of the sawdust blower device, the cutting line can be kept free of dust and chips. Switching on the sawdust blower device: For cuts in materials with high removal rate, such as in wood, plastic, etc. Switching off the sawdust blower device: For cuts in metal and when a dust extraction system (not included) is connected. This tool features a live tool indicator which illuminates as soon as the tool is connected to the supply. This warns the user that the tool is connected and will operate when the switch is pressed. GENERAL All other parts represent an important part of the class II insulation system and should be serviced only by a quali¿ed service technician. [. . . ] Waste electrical products should not be disposed of with household waste. Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. Lay out your pattern or line of cut on top of the "sandwich". WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. [. . . ]