User manual RYOBI ACCSTP1801CRS ACCESSOIRES

[. . . ] Proper interpretation of these symbols will allow you to operate the tool better and more safely. Your manual contains special messages to bring attention to potential safety concerns as well as operating and servicing information. Please read all the information carefully to ensure satification and safe use. Wear eye, and hearing protection when operating this equipment. [. . . ] NOTE: When converting from brushcutter to trimmer, or trimmer to brushcutter, make sure the correct guard/ deflector is being used. Attach the blade guard (5) to the mounting bracket (30); install the four screws (10-24 x 3/4 in) from the top of the mounting clamp through the blade guard and into the threaded mounting plates (32). using the torque wrench supplied , tighten all four screws securely. NOTE: When using the string head (36), the grass deflector (14) must be attached to blade guard. Place the upper flange washer over the gear shaft with the hollow side towards the blade guard. centre the blade on the upper flange , making sure the blade sits flat. Install the cupped washer (40) with the raised centre away from the blade. The blade (6) turns counterclockwise from the operator's position. Place the holding pin through the slot in the upper flange washer and the hole in the gear head (7). Using the 13 mm wrench (42) supplied, turn the blade nut counterclockwise. Attach the grass deflector (14) to the blade guard by placing the three locking tabs (33) into the three notches (31). Always handle fuel with care, it is highly flammable. Always refuel outdoors where there are no sparks and flames. Do not let petrol or oil come in contact with your skin. If petrol or oil comes in contact with the eyes, wash them immediately with clean water. This product is powered by a 2-stroke engine and requires pre-mixing petrol and 2-stroke oil. Pre-mix unleaded petrol and 2-stroke engine oil in a clean container approved for petrol. This engine is certified to operate on unleaded petrol intended for automotive use with an octane rating of 87 ([R + M] / 2) or higher. Tap string head on ground to advance string. String advances each time the head is tapped. Several taps may be required until string strikes the cutoff blade. NOTE: If the string is worn too short you may not be able to advance the string by tapping it on the ground. [. . . ] If there is no spark, repeat the test with a new spark plug. Push primer bulb until the bulb is full of fuel. Make sure the choke lever is set to B and pull the starter cord 10 to 14 times. This clears excess fuel from the engine. [. . . ]