User manual RYOBI AG180 SCHEMA

[. . . ] Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool'' in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. May be used in conjunction with other symbols or pictures. WARNING: Failure to obey a safety warning can result in serious injury to yourself or to others. [. . . ] Do not use the power tool if the switch does not turn it on and off. Any power tool that can not be controlled with the switch is dangerous andmust be repaired. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. Check for misalignment or bindling of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. WARNING Do not allow familiarity with your sander to make you careless. Remember, a careless fraction of a second is sufficient to inflict severe injury. To remove paper, release paper clamp by lifting up on lever, and disengaging it from the tab, and allowing the lever to lower. Lift lever on opposite end of sander and insert loose end of sandpaper under paper clamp. Align holes in hook and loop type sanding paper with holes in pad, then carefully press fuzzy side of sanding paper against pad as tightly as possible. Note: Hook and loop type sanding papers can be reused for the life of the sanding abrasive. It is recommended that you keep the sanding paper backing pad clean to provide for best adhesion. Clean occasionally by brushing lightly with a small brush. A paper punch template has been supplied with your sander for aligning and punching holes in sandpaper. The punched holes must align with the holes in the sander cushion. Excessive pressure will overload the motor causing possible damage from motor overheating and can result in inferior work. [. . . ] To reduce the risk of fire always empty your dust bag frequently while sanding and never store or leave a sander without totally emptying its dust bag. CAUTION Be careful not to let your hand completely cover air vents. Sanding dust is drawn up through the holes of the sanding disc and collected in the dust bag during sanding. WARNING Unsecured work could be thrown towards the operator causing injury. [. . . ]