User manual RYOBI AG30 SCHEMA

[. . . ] WARNING: Failure to obey a safety warning can result in serious injury to yourself or to others. Always follow the safety precautions to reduce the risk of fire, electric shock and personal injury. WARNING: Do not attempt to operate this tool until you have read thoroughly and understood completely safety rules, etc. Failure to comply can result in accidents involving fire, electric shock or serious personal injury. [. . . ] WARNING Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Release switch trigger to turn your saw OFF. 1) Your saw is equipped with a lock-on (3) feature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the switch trigger, push in and hold the lock-on button located on the side of the handle, then release switch trigger. Release lock-on button and your saw will continue running. To release the lock, depress the switch trigger and release. If you have the lock-on feature engaged during use and your saw becomes disconnected from power supply, disengage the lock-on feature immediately. WARNING Before connecting your saw to power supply source, always check to be sure it is not in lockon position (depress and release switch trigger). Check to make sure the back of the saw blade is properly positioned in the groove of the roller guide (12). WARNING To avoid possible serious injury, always wear safety goggles or safety glasses with side shields. Keep hands and fingers away, from the motor housing and blade clamp and do not reach underneath work while blade is cutting. WARNING To avoid serious personal injury, do not use saw without safety guard properly in place. LOW speed is ideal when minimum speed and power is required, for example starting cuts. mEDIUM speed is suitable for cutting hard metals , plastics and laminates. HIGH speed produces best results when maximum power is required, for example cutting wood. 5) Rest the front of the saw base on the workpiece and align cutting edge of the blade with the line on your workpiece. Make sure the power cord is out of the way of saw blade and not in the line of cut. Start your saw and move it forward on the work surface. Apply downward pressure to keep the saw steady and only enough forward pressure to keep the blade cutting. [. . . ] We recommend the use of oil when cutting metals to keep blades cool, increase cutting action, and prolong blade life. Clamp the work firmly and cut close to the clamping point to eliminate any vibration of the workpiece being cut. When cutting conduit, pipe or angle iron, clamp work in a vise if possible and saw close to the vise. To cut thin sheet materials, "sandwich" the material between hardboard or plywood and clamp the layers to eliminate vibration and material tearing. [. . . ]