User manual RYOBI ATLANTIS 120-1 SCHEMA 1

[. . . ] Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes. Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control. [. . . ] Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire. When battery pack is not in use, keep it away from other metal objects like paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. shorting the battery terminals together may cause burns or a fire. Under abusive conditions, liquid may be ejected from the battery; avoid contact. if contact accidentally occurs , flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Exposure to noise can cause hearing loss. Forward Reverse High speed Low speed Drive mode Drill mode (torque adjustment not active) Impact mode Chuck jaws Lock(tighten) Unlock (release) Drill bit(not included) Bit To decrease torque To increase torque Notch Ears Plate Depth stoprod clamp Auxiliary handle assembly Depth Gauge rod Drilling depth Battery Charger Green Light Red Light Keyless chuck Torque adjustment ring Switch trigger Gear train(High-Low) Quick mode selector Direction of rotation selector(forward/reverse/center lock) Bit storage area(s) Magnetic bit holder storage Magnetic tray Magnetic bit holder Battery pack Latches Depress latches to release battery pack 10 CHARGING YOUR BATTERY PACK The battery pack for your tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it prior to use. Note: Batteries will not reach full charge the first time they are charged. Allow several cycles for them to fully charge. Charge battery pack only with the charger provided. Make sure power supply is normal house voltage, 230 volts, 50 Hz, AC only. The variable speed switch trigger delivers higher speed and torque with increased trigger pressure and lower speed with decreased trigger pressure. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When properly connected, red light will turn on. When your battery pack becomes fully charged, the red light will turn off and the green light will turn on. After normal usage, 1 hour of charge time is required to be fully charged. [. . . ] Also, raise the front of the drill slightly to keep the bit /bit holder from falling out of the chuck jaws. Lock the switch trigger by placing the direction of rotation selector in the center position. When using the drill-driver for various driving applications, it becomes necessary to increase or decrease the torque in order to help prevent the possibility of damaging screw heads, threads, workpiece, etc. In general, torque intensity should correspond to the screw diameter. [. . . ]