User manual RYOBI BD1025VR SCHEMA

[. . . ] Then, push the bit as far as it will go and lock it by pushing the stopper shaft to the opposite side. The bit can be removed by following the above method in reverse. Turn the retainer ring counterclockwise until the hole (10) is positioned at the right side. [. . . ] To remove the drill bit, turn the retainer ring clockwise while pushing the retainer lock button (11) until the small hole (10) is positioned at the bottom. Insert the drill bit into the taper shank adapter and strike the tip of drill bit with wooden hammer. To remove the drill bit, place the drill bit on soft material such as wood or plastic. Then, insert the cotter (8) into the hole of adapter and strike it with a hammer. Clean up the dust from the drill hole with the blow-out-bulb (13). Handle should be used during all drilling operations. To drill the desired depth, adjust the depth stopper so that the measure from the end of it to the tip of bit can be equal to the desired depth. Make sure that the tool is only connected to the voltage marked on the name plate. To ensure safe and proper operation, examine the machine for obvious damage before and after use. Damaged parts should be repaired or replaced immediately by an approved RYOBI service organization, using RYOBI spare parts and materials. In regular use, to help know when servicing is required, this machine is fitted with "automatic cut-off" carbon brushes and these carbon brushes will automatically stop the machine from running after approximately 150 operating hours under normal condition of use. This work should be carried out quickly and expertly by any RYOBI service shops, using genuine RYOBI service parts. IMPORTANT The life time of the carbon brushes depends on the usage and environmental conditions. Failure to carry out the maintenance work or failure to use original RYOBI maintenance service parts may cause malfunction of the machine and this will invalidate your warranty. Noise (sound pressure level) in the workplace can exceed 85 dB (A). In this case, sound insulation and hearing protection measures must be taken by the operator. [. . . ] Noise (sound pressure level) in the workplace can exceed 85 dB (A). In this case, sound insulation and hearing protection measures must be taken by the operator. För att borra till önskat djup, ställ in djupstopparen så att avståndet till spetsen på borren motsvararar det önskade djupet. [. . . ]