User manual RYOBI BTS20

[. . . ] (254 mm) TABLE SAW BTS20 - Your new Table Saw has been engineered and manufactured to Ryobi's high standards for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual. Thank you for buying a Ryobi Table Saw. SAVE THIS MANUAL FOR FUTURE REFERENCE + TABLE OF CONTENTS Product Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Failure to do so could result in accidental starting, resulting in serious personal injury. FRONT RAIL WARNING: Drop blade below saw table when reinstalling the throat plate. Failure to heed this warning could result in serious personal injury. To remove the throat plate, first remove the screw holding the throat plate with a phillips screwdriver. With a finger in the finger hole, lift the front end of the throat plate. Firmly pull the throat plate out toward the front of the saw. To reinstall the throat plate, drop blade below saw table and place throat plate in the opening. Push throat plate toward the rear of saw base to engage the spring clip. Insert the throat plate screw and securely tighten. 13 Page 17 ASSEMBLY BLADE AND GUARD ASSEMBLY WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious injury. SMALL HEX WRENCH TO CHECK SAW BLADE INSTALLATION To check the saw blade, first remove the screw holding the throat plate in place. Make sure the bevel locking lever is locked. Raise the blade arbor to its full height by turning the blade adjusting handle counterclockwise. Using the smaller hex wrench, insert the flat open end into the flats on the arbor shaft as shown. Insert the larger hex wrench over the hex nut, and, holding both wrenches firmly, pull the larger wrench forward to the front of the machine to loosen and push to tighten. Make sure the blade nut is securely tightened. Note: Arbor shaft has right-hand threads. Check all clearances for free blade rotation. 14 NOTE: PLACE BLADE BETWEEN INNER AND OUTER BLADE WASHER TO INSTALL BLADE GUARD ASSEMBLY Lower the blade by turning the blade adjustment handle clockwise. Using the small hex wrench, install the blade guard assembly by loosening the two attachment hex nuts enough to slide the riving knife down between the shims. Partially retighten the two attachment nuts. [. . . ] Page 31 LOCKING HANDLE SCREWS RIP FENCE Fig. 41 TROUBLE SHOOTING PROBLEM Excess Vibration. POSSIBLE CAUSE 1. Saw is not mounted securely to a level work surface. SOLUTION 1. Reposition on a level surface and tighten all mounting hardware securely. [. . . ]