User manual RYOBI C2600

[. . . ] (356 mm) Abrasive Cut-Off Machine ­ Model C2600 THANK YOU FOR BUYING A RYOBI ABRASIVE CUT-OFF MACHINE. Your new cut-off machine has been engineered and manufactured to Ryobi's high standards for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. CAUTION: Carefully read through this entire operator's manual before using your new machine. [. . . ] Remember that a careless fraction of a second is sufficient to inflict severe injury. ADJUSTABLE FLIP FENCE ASSEMBLY See Figure 2. The fence on your cut-off machine has been provided to support the workpiece and provide clamping support to the vise for holding your workpiece securely when making all cuts. It is an adjustable flip fence assembly that has been provided to make your cut-off machine more versatile. It adjusts 45° to the right for making angled cuts. It has an extension block that flips down when making cuts in tall or thick stock, such as square stock or tube stock. The extension block flips up out of the way when making cuts in stock that is thin or wide, such as angle stock. MOTOR See Figure 2. This machine has a strong motor with sufficient power to handle tough cutting jobs. It also has externally accessible brushes for ease of servicing. 14 in. (356 mm) abrasive wheel is included with your cutoff machine. (203 mm) wide, depending upon the thickness or width of the material and the setting at which the cut is being made. QUICK LOCK-RELEASE LEVER See Figure 2. A quick lock-release lever has been provided on your cut-off machine. This feature allows you to open and close the vise clamp quickly without repetitive turning of the vise crank handle. MACHINE ARM SELF-RETRACTING LOWER WHEEL GUARD See Figure 2. The lower wheel guard provides protection from each side of SWITCH TRIGGER MOTOR LOWER WHEEL GUARD ADJUSTABLE FLIP FENCE ASSEMBLY EXTENSION BLOCK QUICK LOCKRELEASE LEVER 14 in. (356 mm) ABRASIVE WHEEL VISE CRANK HANDLE VISE SCREW Page 8 VISE CLAMP MACHINE BASE Fig. 2 FEATURES CARRYING HANDLE See Figure 3. For convenience when carrying or transporting your cut-off machine from one place to another, a carrying handle has been provided on top of the machine arm as shown figure 3. To transport, turn off and unplug your machine, then lower machine arm and lock it in the down position. Lock machine arm by pushing in arm lock lever. TRIGGER LOCK See Figure 4. To prevent unauthorized use of your cut-off machine, we suggest that you disconnect it from the power supply and lock the switch in the off position. To lock the switch, install a padlock (not included) through the hole in the switch trigger. When the lock is installed and locked, the switch is inoperable. Store the padlock key in another location. LOCK-ON BUTTON See Figure 3. [. . . ] Fuses or circuit breakers are wrong size or defective. Motor overheats. 1. Request a voltage check from the power company. Wheel is being fed into work too fast. 2. Have the motor checked at your nearest authorized service center. [. . . ]