User manual RYOBI CCG-1801M

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool" in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. cluttered and dark areas invites accidents. [. . . ] If liquid contact eyes, additionally seek medical help. Liquid ejected from the battery may caused irritation or burns. WARNING Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury. Have your power tool serviced by an authorised service centre using only identical replacement parts. This will ensure that the safety of the power tool is maintained. You may use this tool for the following purposes: Sealing cracks to keep your home's conditioned air inside while keeping unconditioned air outside, increasing your home's energy efficiency. Creating a moisture barrier around areas that could be damaged by water. Sealing cracks to keep insects from crawling inside your home. Lock the switch trigger by sliding the switch lock up. Make sure the latches on each side of the battery pack snap into place and the battery pack is secured on the tool before beginning operation. CAUTION When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Using a utility knife, cut off the tip of the spout on a standard 10 oz. Remove as little as possible, taking into consideration the size of the "bead" of caulk you need. check for a second inner seal at the base of the spout. If found, insert the puncture tool inside the spout to break the seal before using. If using a partially filled tube, use the puncture tool to remove any hardened material from the tip. Note: An inner seal is usually found only in cardboard caulk tubes. [. . . ] However, in some cases (particularly where the side materials are rough or uneven), a pulling motion may work better as the cartridge will be less likely to get snagged along the joint. The motor will shut off automatically when a caulk tube becomes empty. Pull the plunger rod back and replace the caulk tube as necessary. to end the caulk bead , release the switch trigger. [. . . ]