User manual RYOBI CHD1202

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool'' in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. 1) WORK AREA a) Keep work area clean and well lit. [. . . ] Liquid ejected from the battery may cause irritation or burns. 6) SERVICE a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage and stress. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: a. That pins on plug of extension cord are the same number, size and shape as those of plug on charger. Do not operate charger with a damaged cord or plug. if damaged , have it replaced immediately by a qualified serviceman. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning. Turning off controls will not reduce this risk. Disconnect charger from power supply when not in use. Refer to them frequently and use them to instruct others who may use this unit. If you loan someone this unit, loan them these instructions also. Model Voltage Chuck Switch No load speed(drill mode): - Lo speed - Hi speed Max. Battery pack Battery pack Charger CHD-1202 12 V 0. To reduce risk of injury, charge only nickel-cadmium type rechargeable batteries. Other types of batteries may burst, causing personal injury and damage. do not expose charger to wet or damp conditions. [. . . ] the drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked. To stop, release switch trigger and allow the chuck to come to a complete stop. Lock the switch trigger by placing the direction of rotation selector in the center position. [. . . ]