User manual RYOBI CMD1802M SCHEMA

[. . . ] 2 Rules for Safe Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-6 Electrical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Glossary of Terms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Unpacking and Tools Needed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] With your left hand firmly on the table tilt handle, grasp the grip with your right hand. Push the leg stand towards the ground with your right hand and pull in the same direction with your left hand until the table saw is in an upright position. 10 Page 15 ASSEMBLY CLOSING THE LEG STAND See Figure 11. Note: You can also refer to the blue label on the top of the table saw for tear-down procedures. Standing to the side of the table saw, grasp the table tilt handle with your left hand. Tilt the table saw to the your left and grab the grip with your right hand. With your right hand on the grip, use your left hand to release the leg stand latch. Once the leg stand is released from the table saw base, ease the legs of the leg stand toward the floor. Place your right hand palm up near the bumper and lift the lower leg of the leg stand up until it locks into place. 11 Page 16 ASSEMBLY TO INSTALL RIP FENCE See Figure 12. To install the rip fence, place the rear lip on the rear rail and pull slightly toward the front of the unit. Lower front end onto the guide surfaces on top of the front rail. Using the small hex wrench, install the blade guard assembly by loosening the two attachment hex nuts enough to slide the riving knife down between the shims. Partially retighten the two attachment nuts. Check the blade and riving knife alignment. Make sure riving knife clears blade by 1/8 in. Correctly align the blade and riving knife as shown, repeating above step as needed. If riving knife is not positioned correctly with blade up, it could contact saw table when blade is lowered and restrict blade elevation. LARGE HEX WRENCH SMALL HEX WRENCH SMALL SPACER TO LOOSEN ARBOR LARGE SPACER INNER BLADE WASHER OUTER BLADE WASHER ARBOR NUT TO TIGHTEN Fig. 15 RIVING KNIFE SHIMS HEX NUTS MOUNTING PLATE DO NOT REMOVE HEX NUTS Fig. 16 Page 18 ASSEMBLY Blade alignment with the riving knife can be adjusted for different blade thickness. Refer to Settings and Adjustments in the Operations Section. Before continuing, read To Check, Replace or Adjust the Blade Guard Assembly on page 23 to make sure of proper riving knife alignment. Check the blade guard assembly for clearances and free movement. [. . . ] Make two or three test cuts on scrap wood. If the cuts are not true, repeat the process. 40 CLAMP SCREW RIP FENCE BLADE WARNING: Before plugging the saw back in to make test cuts, make sure the switch is in the off ( ) position and the blade guard is in place. Failure to do so may result in serious injury. [. . . ]