User manual RYOBI CSD42L

[. . . ] Removing battery pack will prevent accidental starting that could cause serious personal injury. WARNING Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. [. . . ] Use the HI speed setting to drill holes, and use the LO speed setting for driving screws. The tool will stop if the spindle is locked for several seconds while the trigger is on. If this happens, release the trigger, then wait for a few seconds before you resume operation. To avoid this situation, do not force the tool. This feature is convenient when working in close or tight areas where additional light is needed. The light will come on again when the trigger is depressed and operation resumes. The SPEEDLOAD +TM SYSTEM on the screwdriver is a quick change chuck designed to accept any 1/4 in. Insert the bit into the chuck and push as far as possible until the chuck locks onto the bit. To remove a bit, push rubber collar forward, and then pull the bit straight out of the chuck. Use of any other part may create a hazard or cause product damage. Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. [. . . ] the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may signiÀcantly increase the exposure level over the total working period. [. . . ]