User manual RYOBI CTH1202K

[. . . ] 12 to minimise the risk of blade pinching and kickback. When the saw has to be rested on the workpiece, make sure that it rests on the larger portion, with the smaller portion being cut off. Kickback occurs when the saw jams suddenly and is driven back towards the operator. Release the switch immediately if the blade binds or the saw jams. [. . . ] Never lay a tool down before its moving parts have come to a complete stop. ACCESSORIES: The use of equipment or accessories other than those recommended in this manual might present a hazard. This saw is designed for working with wood only. Never use it to cut materials other than wood. Make sure that the saw blade is properly attached as described in the Operating Instructions before connecting the tool to the power source. Never point the blade towards any person since this is extremely dangerous. Make sure the power cord is well away from the material to be cut to prevent the risk of electrical shocks. Hold the saw firmly before switching it on, as inertial force could cause the saw to break free from your grasp. Always hold the saw firmly with both hands while cutting. The distance between the riving knife and the toothed rim of the saw blade is not more than 5 mm. The toothed rim does not extend more than 5 mm beyond the lower edge of the riving knife. When the tool is used outdoors, use only extension cords intended for outdoor use. Blade diameter (Use only blades of this diameter) Blade bore diameter Max. Cutting capacities at 0° at 45° Frequency Voltage Input WS-6613 WS-6615 / CTH1202K No load speed WS-6613 WS-6615 / CTH1202K Net weight WS-6613 / CTH1202K WS-6615 Noise (sound pressure level) in the workplace can exceed 85 dB. In this case, sound insulation and hearing protection measures must be taken by the operator. Pressing the spindle lock button (1), turn the hex-head bolt (2) with the spanner (3) until the spindle locks. Loosen the hex-head bolt by turning the spanner anticlockwise while pressing the spindle lock button. Retract the lower guard (5) back with the lower guard lever (6) as far as possible under the upper guard (7). Then, attach the saw blade (8) against the inner blade washer (9) on the spindle. Press the spindle lock button again, tighten the hexhead bolt by turning the spanner clockwise while pressing the spindle lock button. After tightening the hex-head bolt, release the spindle lock button. This tool is started and stopped by squeezing and releasing the trigger switch (18). [. . . ] After use, check the tool to make sure that it is in top condition. We recommended that you take this tool to an Authorised Ryobi Service Centre for a thorough cleaning and lubrication at least once a year. For greater safety and reliability, all repairs should be performed by an Authorised Ryobi Service Centre. The depth of cut (14) can be determined by the depth scale (15) or by measuring the distance by which the blade protrudes from the base plate. [. . . ]