User manual RYOBI ED265VKI SCHEMA ELECTRIC

[. . . ] 31 2 Contents Additional options . 34 General problems with the dishwasher . 45 Cleaning the drain pump and non-return valve . 55 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. [. . . ] ^ Press the K button to turn the dishwasher on. The "Start / Stop" indicator light flashes and the indicator of the last set program lights up. Starting a program ^ Select the desired program with the Program selection button. The indicator light for the selected program will come on. The "Start / Stop", "Wash" indicators and the indicator of the selected program come on. Cancel a program only in the first few minutes. the water softening) may be interrupted. Selecting a program Choose your program according to the type of load and soiling. See the "Program Guide" for more information. You can now select any additional options if desired (see "Additional Options"). Program sequence display Once a program has been started the current stage of the program is shown in the program sequence display by the indicator lights. 28 Use Program Guide Progra m guide When to use Pre-rinse 1 Pots & Pans For normally soiled pots & pans with dried on food, and heavily soiled dishware, use 120% detergent recommended. X 2 Program sequence Main wash X Interim rinse 1 X 2 Final rinse X Drying X Normal as required Program for completely washing a full load of normally soiled dishware with the ability to adjust energy and water consumption based on the soil load of the dishware. For temperature sensitive glassware and lightly soiled dishware, use 50% detergent recommended. X X X X X China & Crystal X X X X SaniWash To sanitize dishware, e. g. Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. 31 Additional options Factory default All settings can be reset to factory default. ^ Press the K button to turn the dishwasher off. ^ Press and hold the Start / Stop button and turn the dishwasher on simultaneously using the K button. Keep the Start / Stop button pressed for at least four seconds until the "Start / Stop" indicator light comes on. The lower most program indicator flashes once long and twice short. The "Cleaning" progress indicator shows whether a setting has been set differently to the default setting. ­ "Cleaning" progress indicator flashes: All values are set to the default settings ­ "Cleaning" progress indicator is off: At least one setting has been changed. ^ Press the ''Start / Stop" button if you wish to reset the dishwasher to the default settings. ^ Press the K button to turn the dishwasher off. 32 Frequently asked questions , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. [. . . ] 140°F / 60°C) or cold water source. For lowest energy consumption and fastest possible wash times connect the dishwasher to a hot water source. All programs use hot water in the rinse cycles. ­ The inlet hose is approximately 5 ft. [. . . ]