User manual RYOBI EHG-2002C

[. . . ] Check the area where the heat gun is to be used. Behind ceiling, floors and false ceilings may contain highly flammable material. Always check these before using the heat gun. Keep the work area clean and uncluttered. [. . . ] Heat guns have a safety cut-off which will stop the heat gun if you are working too close to the surface being stripped. If the cut-off operates, the hot air gun must be allowed to cool for about 30 minutes before it can be used again. Never use the heat gun in combination with solvents. After use, remove any paint or varnish residue on the nozzle and scrappers. Ensure that the power supply corresponds to the rating plate on the heat gun. The power supply should be 230V 50Hz AC (normal mains). Voltage deviation greater than 10% may cause loss of power and possible overheat. For greater safety, the heat gun is double insulated. This means that there are two separate insulation systems between the user and the live elements of the heat gun. WARNING Although the heat gun is double insulated, normal safety precautions should be taken when using the heat gun to avoid injury that may be caused by a failure of the electrial installation inside the equipment. This tools are not designed to be earthed. The heat gun power cable is, therefore, fitted with a two pin plug for use in normal 230V power sockets. Before plugging the heat gun in, always ensure that the switch is set to 0 (OFF). When you are ready, adjust the switch (4) to setting1 or 2. Always allow the heat gun to warm up for at least 1minute to reach to operating temperature. The heat gun has a built-in stand to keep it upright on a flat horizontal surface. This leaves both hands free for softening PVC pipes or other material. Always keep your hands away from the nozzle. If your heat gun model has variable temperature control (3) / LCD which you can rotate to adjust to different temperature. If your heat gun model has LED temperature indicator (6) (Fig. 4) or LCD temperature indicator (7) (Fig. 5) then you can take a reference on the LED/LCD indicator to know what is the approximate working temperature. [. . . ] The thermostat will automatically reset after 30 minutes until the unit cool down and normal use can then be resumed. Failure to follow this instruction may result in damage to the machine and personal injury. Blaasmond Beschermhuls Temperatuurregelaar (alleen modellen EHG-2002LED/LCD) Aan-/uitschakelaar Achtersteun voor verticale opstelling Temperatuurindicatorlampjes (alleen model EHG-2002LED) Temperatuurindicatie via lcd-scherm (alleen model EHG-2002LCD) Se till att munstycket och lufttilloppet till värmepistolen hålls rena och fria från damm och smuts. All Ryobi products are guaranteed against manufacturing defects and defective parts for a period of twenty four (24) months from the date stated on the original invoice drawn up by the retailer and given to the end user. [. . . ]