User manual RYOBI EMS1426L SCHEMA

[. . . ] There is an increased risk of electric shock if your body is earthed or grounded. c) Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. Never use the cord for carrying, pulling or unplugging the power tool. [. . . ] Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. g) If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. The eye protection must be capable of stopping flying debris generated by various operations. The dust mask or respirator must be capable of filtrating particles generated by your operation. Prolonged exposure to high intensity noise may cause hearing loss. C) Keep bystanders a safe distance away from work area. Anyone entering the work area must wear personal protective equipment. Fragments of the workpiece or of a broken accessory may fly away and cause injury beyond the immediate area of operation. D) Hold the power tool only by the insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own power cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and shock the operator. E) Position the cord clear of the spinning accessory. If you lose control, the cord may be cut or snagged and your hand or arm may be pulled into the spinning accessory. 9 F) Never lay the power tool down until the accessory has come to a complete stop. [. . . ] ONLY): · Do not connect the blue (= neutral) or brown (= live) wire in the cord of this tool to the earth terminal of the plug · If for any reason the old plug is cut off the cord of this tool, it must be disposed of safely and not left unattended · · · · · USE · Mounting of accessories 6 !switch off the tool and disconnect the plug !ensure that collet size corresponds with shaft size of accessory - push spindle-lock button A and hold it while you turn collet nut B by hand until the spindle lock prevents further rotation and loosen collet nut B with wrench C !push spindle-lock button A only when tool is at a standstill - insert required accessory in collet D (leave approximately 3 mm of the shaft exposed) · - push spindle-lock button A and hold it while you tighten collet nut B with wrench C ! [. . . ]