User manual RYOBI G1850 SCHEMA ELECTRIC

[. . . ] 28 2 Contents Additional options . 31 General problems with the dishwasher . 41 Cleaning the drain pump and non-return valve . 50 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. [. . . ] This will enable the temperature in the wash cabinet to settle. Close the door firmly until it clicks into place. Changing a program If the detergent flap is already open do not change the program. If a program has already started and you wish to change it: ^ Press the "Start/Stop" button for at least one second. The "Start/Stop" indicator lights. ^ Select and start the desired program. 27 Program Guide Program guide When to use Pre-rinse 1 2 Program sequence Main wash X Interim rinse 1 2 Final Drying rinse X X Pots & Pans For normally soiled pots & pans with dried on food, and heavily soiled dishware, use 120% detergent recommended. Program for completely washing a full load of normally soiled dishware with the ability to adjust energy and water consumption based on the soil load of the dishware. For normally soiled dishware, energy saving program with a long soaking time and a low temperature To sanitize dishware, e. g. baby bottles, cutting boards and preparation dishware. "Quick program" for lightly soiled dishware, e. g. party dishware or to remove salt traces from the wash cabinet after refilling salt, not suitable for detergent tabs. To rinse dishes when a complete program is not needed. X Normal as required X X X X Economy X X X X SaniWash X X X X Express X X X X Rinse & Hold X Usage: Electrical - 0. 01 - 1. 23 kWh Water - 1. 3 - 6. 3 gal (5 - 24 l) 28 Additional options Default settings All settings can be reset to the factory default. Solution Open the water supply all the way. Before fixing the fault: ­ Turn the dishwasher off "s". ­ Open the water supply all the way. ­ Clean the water intake filter, see "Cleaning and care". ­ The water pressure at the water connection is lower than 4. 35 psi. Consult a plumber. Water drain fault. There may be water in the ­ Clean the drain pump wash cabinet. See "Cleaning and care" for more information on the above. ­ Remove any kinks in the drain hose. 31 Frequently asked questions General problems with the dishwasher Problem The indicators and the display is dark. Only the "Start/Stop" indicator flashes slowly. Detergent is left in the dispenser at the end of a program. [. . . ] ­ If the water pressure if lower, a "Water Intake" notification will be shown. See "Frequently Asked Questions" for more information. ­ If the water pressure is higher than shown, a pressure reducing valve must be used. Ensure that the water connection is secure after the first use. , Installation, repairs and other dishwasher! , Do not drink water from the ­ The dishwasher can heat its own water to the temperature required by the wash program. [. . . ]