User manual RYOBI G2355I SCHEMA ELECTRIC

[. . . ] Connecting the vacuum cleaner to a higher voltage may result in damage to the vacuum cleaner or injury. This appliance has a polarized plug (one blade is wider than the other. ) This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. [. . . ] ^ Press the telescopic wand release button to release the tubes and adjust to the desired height. Using the standard floor brush Observe the cleaning instructions of the floor manufacturer. The floor brush is suitable for cleaning carpets, rugs, carpeted stairs and hard surfaces that are not susceptible to scratching. Connecting the floor brush ^ Place the floor brush into a the suction hose and twist until it clicks into place. ^ To separate the parts b, press the lock release button and pull apart. Adjusting the floor brush c For vacuuming carpets and rugs, lower the tool by: ^ pressing the foot switch marked ö. For cleaning smooth floors, raise the tool by: ^ pressing the foot switch marked ä. 11 Using the included accessories The following accessories are included: a Dust brush with natural bristles b Upholstery tool c Crevice nozzle d Accessory clip for the included accessories Position the accessories as indicated. Accessory clip ^ Press the accessory clip either above the hose connector or below the suction hose. Floor brush The floor brush is suitable for cleaning carpets, rugs, carpeted stairs and hard surfaces that are not susceptible to scratching. For safety, when vacuuming stairs it is best to start at the bottom and move upwards. ^ Open the air inlet valve far enough to reduce the suction power. Opening the air inlet valve reduces the power to the tool being used. 15 Transport and storage Park-System (unable to be used with the Powerbrush SEB 228 / EB03. ) The Park system allows you to conveniently park the wand and floor brush on the vacuum cleaner during brief pauses. ^ Insert the lower clip on the floor brush into the slot on the end of the vacuum cleaner from above. Transport and storage ^ For easier transportation and storage stand the vacuum cleaner vertically. ^ Insert the parking clip attachment on the floor brush into the parking slot from above (does not apply to Powerbrush SEB 228 / EB03). If you model includes a telescopic wand, to save space completely collapse the tubes in the telescopic wand. If your model includes an EasyLock wand, to save space: ^ Press the lock release on the lower wand, the two wands will separate. ^ Put the connection piece of the upper wand into the lower wand. 16 Maintenance and care , Turn off and unplug the vacuum Purchasing new dustbags and filters Original Miele dustbags and filters can be purchased from an authorized Miele vacuum dealer or by visiting the Miele store at http://store. [. . . ] This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust. A heavily soiled exhaust or dust compartment filter can also be the cause of overheating. Turn the vacuum off s and pull the plug from the outlet. Check for any blockages and allow the vacuum to cool for 30 minutes. [. . . ]