User manual RYOBI HP721K

[. . . ] CAUTION: Carefully read through this entire operator's manual before using your new cordless drill-driver. Pay close attention to the Rules for Safe Operation, Warnings, and Cautions. If you use your cordless drill-driver properly and only for what it is intended, you will enjoy years of safe, reliable service. Thank you again for buying Ryobi tools. SAVE THIS MANUAL FOR FUTURE REFERENCE 1 3 5 TABLE OF CONTENTS s Table Of Contents/Typical Applications. [. . . ] It does not occur under normal circumstances. Refer to "Charging Your Drill-Driver" for normal recharging of batteries. If the charger/charging assembly does not charge your battery pack under normal circumstances, return both the battery pack and charger/charging assembly to your nearest Ryobi Authorized Service Center for electrical check. DISPOSAL OF THE EXHAUSTED BATTERY C YCL RE B R CE R 1. 8 To preserve natural resources, please recycle or dispose of properly. This product contains nickel-cadmium battery. 1 BATTERY CHARGER CHARGE INDICATOR LIGHT (LED) TO CHARGE MODEL NO. HP721KK s s s s Charge battery pack only with the charger provided. Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only. The charge indicator light (LED) indicator, which is located on rear of battery pack, will light up when charger is properly connected to power supply. This red light indicates your drill is charging and will remain on until charger is disconnected from power supply. Charge battery pack only with the charging assembly provided. Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only. HP961/HP1201 have a variable speed feature in the switch. The switch delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression. CENTER POSITION (LOCK) 1 3 5 7 SWITCH TRIGGER FORWARD Fig. The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direction of rotation selector in the center position. 9 7 s s Place the direction of rotation selector in center position. Align raised rib on battery pack with groove in drill's battery port. Make sure the latches on each side of your battery pack snap in place and that battery pack is secured in drill before beginning operation. Place the direction of rotation selector in center position. Locate latches on side of battery pack and depress both sides to release battery pack from your drill. BATTERY PORT s TO REMOVE BATTERY PACK s s BATTERY PACK 1 TO INSTALL BATTERY PACK 3 5 s LATCHES CAUTION: When placing battery pack in your drill, be sure raised rib on battery pack aligns with groove in drill's battery port and latches snap in place properly. [. . . ] Use of any other parts may create a hazard or cause product damage. Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use a clean cloth to remove dirt, oil, grease, etc. [. . . ]