User manual RYOBI IDC130

[. . . ] Read the user's manual carefully for complete safety, assembly, operating, maintenance and repair instructions. MEANING NO-HANDS SYMBOL Keep your hands away from the blade to avoid all risks of serious personal injury. READ THE USER'S MANUAL Please read the user's manual before starting or operating this machine. Follow operating instructions and safety precautions in this manual. [. . . ] Before using your mitre saw, connect it to a dust extractor. When sawing long workpieces, always use extension wings to provide better support, and use clamps or other holding devices. When the noise level exceeds 85 dB (A), be sure to wear ear protection. 1) When using the machine, keep hands at least 10 cm from path of blade. Hold workpiece firmly against the fence to prevent movement towards the blade. Keep hands in the same position until the blade has completely stopped. Before making a cut, do a "dry run" with the power off so you can see the path of the blade. Dimensions L x W x H Table size Saw blade TCT Adjustment Mains power supply Motor capacity Weight Cutting capacity Mitre (°) 90 45 45 90 Bevel (°) 90 90 45 45 Depth (mm) 54 54 37 45 Width (mm) 130 90 90 130 390 X 350 X 380 mm 390 X 160 mm TCT 20T 3 X 45° 230 Volt (110V model requires 110V transformer) 1200 Watt 8. Freehand A cut performed without using a fence, mitre gauge, holding device, work clamp, or other appropriate device to keep the workpiece in place during the cut. gum A sticky , sap-based residue from wood products. Mitre Cut A cutting operation made with the wood at any angle other than 90 degrees to the fence. Numerous motor problems are caused by loose or incorrect connections, overload, insufficient voltage (due to small size wire in the supply circuit) or overly long supply circuit cables. Always check the connections, the load and the supply circuit whenever the motor doesn't run properly. Wire sizes The use of extension cables will cause some loss of power. To keep this to a minimum and to prevent overheating and motor damage, use the table below to determine the minimum wire size (lead cross-section) of an extension cable. For circuits that are more than 40 m away from the electrical service box, the thickness of the wire should be increased proportionately in order to deliver sufficient voltage to the saw motor. Handle latch The mitre saw can be locked in the lowered position for compact storage B. The saw is shipped with the fence in the rear position. Bevel lock handle The bevel lock handle locks the mitre saw at the desired bevel angle. Power Cable The power cable connects the saw to a 230 V/50 Hz power outlet. Lower Blade Guard The blade guard helps protect your hands when the blade is in the raised position. Mitre saw handle The saw handle has a trigger switch with a lock button. [. . . ] Lower the blade and lock the handle latch. Use a combination square to check blade squareness to the table. If the blade does not contact the full length of the square, follow the alignment procedure. Grasp the upper blade guard and move the sawhead to the left as far as it will go. [. . . ]