User manual RYOBI LS35

[. . . ] For repairs, you should take the tool to your nearest Authorised RYOBI Service Centre. Only manufacturer's original replacement parts must be used. WARNING: Do not attempt to use this tool until you have fully read and understood all the safety instructions contained in this manual. Failure to comply with these instructions could result in accidents such as fire, electric shock or serious personal injury. [. . . ] When using an extension cord, be sure to use one with adequate wattage rating. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. When the tool is used outdoors, use only earthed extension cords that are approved for outdoor use and marked as such. Do not wear loose clothing, gloves, ties, rings, bracelets or other jewellery. They can get caught in the tool and draw you into the moving parts, possibly resulting in serious injury. Rubber gloves and non-skid footwear are recommended when working outdoors. If you have long hair, tie it back and wear protective hair covering to keep it from being drawn into the ventilation slots. aLWAYS WEAR SAFETY GLASSES WITH SIDE SHIELDS. Ordinary glasses have only impact-resistant lenses; they are NOT safety glasses. Wear a face mask or dust mask if the work generates dust. During extended periods of operation, wear proper hearing protection to dampen the sound pressure level . MAKE SURE THE WORK AREA IS WELL LIT so that you can clearly see what you are doing and that there are no hazards BEFORE you start using your tool. When not in use, the tool should be stored in a dry place which is high enough to be out of children's reach or under lock. nEVER TOUCH MOVING PARTS when the tool is operating. Never start a tool when one of its moving parts is in contact with the work place. ALWAYS PUT THE TOOL IN THE "OFF" POSITION before disconnecting it, to avoid accidental starting when you plug the tool back in. Refer to them frequently and use them to instruct others who may use this tool. If you lend this tool to someone, lend them these instructions as well. Due to Ryobi's ongoing product improvement policy, tool features and specifications are likely to change without notice. Use the spanner to loosen the three securing nuts on the blade holder. Push the blade out of the blade holder using the spanner. Slide the new blade into the blade holder. [. . . ] For easier and more precise chamfering, use the chamfering guide as illustrated in Fig. Your Ryobi planer is designed to accept a dust bag which can be fitted to the left or right chip deflector outlet as illustrated in Fig. To inspect or replace the driving belt, remove the driving belt cover by loosening the screw as shown in Fig. Ensure that the driving belt cover is securely put back before beginning operation. [. . . ]