User manual RYOBI LTS180M SCHEMA

[. . . ] · Specifications may differ from country to country. GENERAL SAFETY RULES (For All Tools) USA002-2 WARNING: Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. SAVE THESE INSTRUCTIONS Work Area 1. Cluttered benches and dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. [. . . ] Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Ordinary eye or sun glasses are NOT safety glasses. Inspect workpiece for any nails and remove them before operation. Check for the proper clearance beyond the workpiece before cutting so that the blade will not strike the floor, workbench, etc. Make sure the blade is not contacting the workpiece before the switch is turned on. Always switch off and wait for the blade to come to a complete stop before removing the blade from the workpiece. 12. Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow material supplier safety data. SAVE THESE INSTRUCTIONS WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. 5 FUNCTIONAL DESCRIPTION · CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 002704 Selecting the cutting action This tool can be operated with an orbital or a straight line (up and down) cutting action. The orbital cutting action thrusts the blade forward on the cutting stroke and greatly increases cutting speed. Blade With the blade teeth facing forward, insert the blade into the blade holder as far as it will go. Make sure that the back edge of the blade fits into the roller. Then tighten the bolt clockwise to secure the blade. To remove the blade, follow the installation procedure in reverse. NOTE: · Occasionally lubricate the roller. 002727 Hex wrench storage When not in use, store the hex wrench as shown in the figure to keep it from being lost. 1 2 1. Hex wrench 8 Dust cover 002730 · 1 CAUTION: Always wear safety goggles even when operating the tool with the dust cover lowered. Lower the dust cover to prevent chips from flying. However, when making bevel cuts, raise it all the way. 1. Dust cover 002732 Anti-splintering device (optional accessory) For splinter-free cuts, the anti-splintering device can be used. To install the anti-splintering device, move the base all the way forward and insert it between the two protrusions of the base. 1 2 1. Protrusions NOTE: · The anti-splintering device cannot be used when making bevel cuts. OPERATION CAUTION: · Always hold the base flush with the workpiece. Failure to do so may cause blade breakage, resulting in a serious injury. [. . . ] Prospect, IL 60056-6011 (847) 297-3100 NEVADA 3375 S. 22 - 24 Las Vegas, NV 89102 (702) 368-4277 TENNESSEE 1120 Elm Hill P. Suile 170 Nashville, TN 372 (615) 248-3321 MARYLAND 7397 Washington Boulevard, Suite 104 Elkridge, MD 21075 (410) 796-4401 NEW JERSEY 251 Herrod Blvd. Dayton, NJ 08810-1539 (609) 655-1212 TEXAS 12801 Stemmons Fwy Ste. [. . . ]