User manual RYOBI RE601

[. . . ] OWNER'S OPERATING MANUAL Electronic Plunge Router Heavy Duty Model RE601 Variable Speed / Double Insulated 1 1 in cm 2 3 3 9 SPECIFICATIONS: Depth Of Plunge Cut Maximum Cutter Diameter Collet Bit Adapter Included With Packaging Amperes / Horsepower Rating No Load Speed Power Cord Net Weight 0 - 2-3/8 in. (6. 4 mm) 15 Amperes / 3 Hp 120 Volts, 60 Hz, AC Only 10, 000 - 22, 000 RPM 10 ft. (7. 05 kg. ) THANK YOU FOR BUYING A RYOBI ROUTER. Your new router has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. [. . . ] I Turn adjustment knob and adjust stop bar until it touches the desired stop screw. Depth control knob is spring loaded against hex nut. If you adjust it too far and it pops off threaded rod, refer to DEPTH CONTROL KNOB ADJUSTMENTS in maintenance section for proper assembly. DEPTH CONTROL KNOB See Figure 11. Fine adjustments can be made to the depth of cut by use of the depth control knob. Another primary use of the depth control knob is setting depth of cut when router is mounted upside down on a router table. NOTE: The weight of the router plus the position it is in when mounted to a router table make it necessary to use the depth control knob. TO SET DEPTH OF CUT WITH DEPTH CONTROL KNOB I Unplug your router. WARNING: Failure to unplug your router could result in accidental starting causing serious injury. I Loosen lock knob and turn adjustment knob so that stop bar is not touching stop screws. Page 12 ADJUSTMENTS SCALE See Figure 12. Your router has a dual inch and metric scale provided on the stop bar. Each mark on the inch scale makes 1/16 in. Each mark on the centimeter scale makes 1 mm depth of cut changes possible. The indicator point located on the housing provides a reference point for the scale. I Select either the inch or metric indicator point. I Identify the scale mark currently aligned with the indicator mark. I Loosen lock knob and turn adjustment knob to change the scale and stop bar position. I Continue to turn adjustment knob until the indicator point aligns with the new desired depth of cut mark on the scale. I Tighten lock knob securely to lock stop bar in new position. The cutter position will now increase or decrease the exact distance the stop bar was adjusted. depth of cut is needed, loosen lock knob and turn adjustment knob further until indicator point aligns with the next 1/16 in. Tighten lock knob securely to lock stop bar in new position. Repeat the steps above as needed if a deeper depth of cut is required. Remember: The inch marks on the scale indicate a 1/16 in. change in depth setting; each mark on the centimeter scale side of the stop bar equals a 1 mm change in depth setting; the depth control knob can also be used for making precise or fine adjustments to depth of cut; and depressing center of depth adjustment knob quick releases stop bar. 1 INDICATOR POINT 1 1 in cm 2 3 64 2 3 in cm 2 2 1 3 2 3 4 3 3 8 9 3 8 9 Fig. [. . . ] Template Guide Adapter - Accepts all Ryobi template guides Template Guide Adapter - Accepts Porter-Cable, Rockwell, and Black & Decker template guides Straight Guide Holder Straight Guide (requires straight guide holder #6070573 above) 1/2 in. (6. 4 mm) Bit Adapter Phillips Flat Head Screws for router table mounting - M8 x 25 - Set of 4 24 mm Wrench * Included with your router as standard accessories HELPFUL HINTS Always clamp workpiece securely before routing. A safe operator is one who thinks ahead. Always wear eye protection when routing. [. . . ]