User manual RYOBI RESV1000 SCHEMA ELECTRIC

[. . . ] When using your appliance follow basic safety precautions including the following: Installation ~ Be certain your appliance is properly installed and grounded by a qualified technician in accordance with national and local safety regulations. main electrical supply using an extension cord. Extension cords do not meet the safety requirements of this appliance. this appliance, continuity must exist between the appliance and an effective grounding system. [. . . ] If any burners are still hot the residual heat indicator will show in the respective display. The residual heat indicator also reacts to hot dishes and plates being placed on a burner that is not switched on. Do not touch any burner or place any heat sensitive items on a burner where the residual heat indicator is lit. Danger of burns, and fire hazard. , Please note that the residual heat indicators do not light when there is a fault message, even if the burners are hot. 23 Timer The cooktop is fitted with a timer which can be used to time kitchen activities and/or to switch off the burners automatically. You can set a time from 1 minute (01) to 9 ½ hours (9. ^). If the time is more than 99 minutes (99), the setting will be shown in half-hour increments, which appear after the decimal point. Use the - and + touch controls to raise and lower the time. There are pre-set stops at 2 hours and at 99 minutes. To override a stop, briefly remove your finger from the touch control, then touch it again to continue. To re-set the display to 00, simultaneously touch - and +. When the set time has elapsed, 00 will appear in the timer display for a few seconds. Starting with the shortest remaining time which is shown in the display, all burners that are in use and the timer can be selected clockwise. 26 Safety features Child Safety Lock Keep children away from the cooktop for their own safety. The cooktop has a Child Safety Lock to prevent children from turning on the burners or changing settings. The Child Safety Lock can be activated while the cooktop is on or off. Activating the Child Safety Lock during cooktop use ­ The settings for the burners and timer cannot be altered. ­ The burners and cooktop can still be turned off but once turned off cannot be turned on again. Activating the Child Safety Lock when the cooktop is turned off ­ The cooktop cannot be turned on. Manual activation ^ Press and hold the $ Child Safety Lock control until the respective indicator lights. The indicator will go out after a short time. You can alter the setting from one finger to three finger operation (see "Programming - P6") to make it harder for children to operate the appliance. Automatic activation The Safety lock will come on 5 minutes after the cooktop is switched off. To use this feature the setting has be changed (see "Programming - P7"). Deactivation ^ Press and hold the $ Child Safety Lock control until the indicator goes out. The indicator will come on to show that the Child Safety Lock has been activated, if you touch the $ Child Safety Lock control or try to select a setting. In the case of a power failure the Child Safety Lock will be deactivated. 27 Safety features Stop and Go Your appliance has a Stop and Go feature which, when activated, reduces the power of all burners that have been switched on. If you then deactivate the feature, the burners will automatically return to the previous level. [. . . ] See also the "IMPORTANT SAFETY INSTRUCTIONS". ^ Seal the cut surfaces with a suitable heat-resistant sealant to avoid swelling caused by moisture. If during installation the seal around the frame does not sit flush with the countertop in the corners, the corner radius, maximum 3/16" (4 mm), can be carefully filed down to fit. This cooktop has a seal underneath to keep it securely in position. [. . . ]