User manual RYOBI RET 1000

[. . . ] ⷠBefore starting, make sure that the cutting head is not in contact with anything, such as a branch, stone. ⷠUse the unit only in daylight or good artificial light. ⷠBe aware of the risk of injury ta the head, hands and feet. [. . . ] ⷠThe table (below) shows the correct size to use depending on the cord length and nameplate amperage rating. If in doubt, use the next heavier size Iine gauge. Keep Wear head, bystanders at least 15 m eye and ear away from protection. If the electric cord is damaged Do not Ignition/ Ignition/ remove plug operate unit Power Switch Power Switch from socket in rain. Push the D-handle down onto the boom (Fig. Place the string guard onto the boom above the clamp assembly (Fig. Fit the safety protection onto the bar above the coupling joint in the direction of the motor (fig. 4 for putting the safety protection extension into position. CONNECTING THE CORD To prevent disconnection when you connect the extension cord to the power cord, use the cord hook (Fig. ADJUSTING LINE LENGTH The trimmer has a bump (cutting) head, which releases more trimming line without stopping the motor. When the cord starts to get a bit short, knock the cutting head on the bare ground or on hard ground to make the appliance work at top speed. Repeat the process as often as necessary (Fig. EDGING When edging, let the tip of the trimming line do the work (fig. The cutting head will be at the correct angle by holding it parallel to the ground. [. . . ] Hang the unit by the handle loop and store it in a dry, well-ventilated area, out of the reach of children. MODEL Motor Motor Operating RPM Ignition Switch Drive shaft Cutting head Vibration Level Sound pressure level (no load) Sound power level (no load) Cutting path diameter Operating weight Trimming line Motor stops / will not start 2. Cutting head bound with grass or debris · Cutting head will not turn when throttle is squeezed 1. [. . . ]