User manual RYOBI RFT254

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. EN FR Injuries may be caused, or aggravated, by prolonged use of a tool. When using any tool for prolonged periods, ensure you take regular breaks. Subject to technical modifications / Sous réserve de modifications techniques English(Original instructions) Your product has been engineered and manufactured to Ryobi’s high standard for dependability, ease of operation, and operator safety. [. . . ] Slightly rotate from side to side until the button is locked into place. If needed, turn the trimmer head which will aid in the insertion of the shaft. –■ Remove two handlebar knobs and two bolts from the hardware bag. –■ Place the lower handlebar into the openings on the trimmer power head/wheel assembly as shown. NOTE: Do not allow throttle cable to become pinched when installing the handlebar. –■ Insert the bolts through the holes in the handlebar and frame. –■ Remove two handlebar knobs and bolts from the hardware bag. ■■ Position upper handlebar onto lower handlebar. Make sure the throttle cable and throttle trigger are on the right side as shown. –■ Insert bolt through plastic clip, then through holes. NOTE: Do not allow throttle cable to become pinched when installing the handlebar. –■ Align the holes in the clip, the upper handlebar and lower handlebar. Use quality monofilament replacement line for best performance. –■ Stop the engine and disconnect the spark plug wire. –■ Gather two of the pre-cut lengths of trimmer line provided or cut two pieces of trimmer line in 25. –■ Insert the lines into the load slots located on the sides of the string head. Line should be pushed in until approximately 2 cm protrudes from the holes on the top of the string head. –■ Remove old line by pulling it from the holes located on the top of the string head. 8 WARNING Do not remove screws or disassemble string head. If head is opened, compression springs could fly out toward operator and result in serious injury. The line carrier snaps onto the upper handlebar on the side opposite the throttle cable and is used to hold pre-cut pieces of trimmer line. NOTE: Do not install the carrier where it could interfere with the throttle cable or where it could cover any of the warning icons or labels. [. . . ] The product is designed and dedicated to consumer and private use only. Promotion, range of tools), a possibility to extend the warranty period over the period described above using the registration on the www. The eligibility of the tool is clearly displayed in stores and/or on packaging. The end user needs to register his/her newly-acquired tools online within 8 days from the date of purchase. [. . . ]