User manual RYOBI RHP1150 AM SCHEMA ELECTRIC

[. . . ] For installation of the cover, a minimum distance of 20" (510 mm) is required between the countertop and wall cabinetry. Note: The wok/pan support should be removed before lowering the stainless steel cover (EA 80). j Ignition safety control k Burner base l Control for burner m Control panel Do not install the Da 8-2 directly next to the gas hob. 3 Contents Contents Description of the appliance . 17 For the installer / electrician / engineer ]ö Electrical connection . 23 ]ö Instructions for building-in. [. . . ] the burner does not ignite after several attempts?Check whether: the large burner cap and the large burner cap base are correctly positioned. In this case call an electrician or the Miele Service Dept. Use a match to light the gas (see page 11). the shape and color of the flame are different from usual?Check whether the burner caps and large burner cap base are correctly positioned. Check whether the large burner cap and the large burner cap base are correctly positioned. Check for food residues covering the tip of the ignition safety control. Check, whether the orifices of the small burner cap are clean, especially those toward the tip of the ignition safety control. Follow the procedure on how to start the flame from top left of page 11, do not forget to depress the knob to the bottom before releasing after 5­10 seconds. the electric spark ignition for the gas burner no longer works?WARNING THIS APPLIANCE MUST BE EARTHED. Technical data AUS (NZ) Total connected load . 1. 10 m If the connection cable needs replacing, only use cable with at least 3 x 1 mm2. 19 ]ö Gas connection ]ö Gas connection This appliance must be installed with a separate shut-off valve and a gas pressure regulator. Both shut-off valve and pressure regulator must be easily accessible to the consumer. This appliance and its individual shut-off valve must be disconnected from the gas supply during any pressure testing of that system at test pressures in excess of 1/2 PSI (3. 5 kPa). This appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 PSI (3. 5 kPa). Any pipe connections must be made using a thread sealant approved for gas connections. Failure to correctly install these items could lead to a gas leak and subsequent explosion. For convenience, an approved type of flexible stainless steel gas pipe (accordion type) may be installed between the adapter and the regulator. This will allow the unit to be lifted for cleaning or servicing. Ensure that any drawers, cabinet doors, etc. If an elbow adapter is necessary for your particular installation, a customized one ­ can be obtained free of charge from the Miele parts department (USA). [. . . ] 0. 90 0. 23 No 2 0. 52 0. 23 No 2 0. 52 Conversion LPG LPG Changes for LPG Propane: jets, adjusting screws, regulator, Propane label. Changes for LPG: jets, adjusting screws, regulator, LPG label. Turn off the gas mains (if this appliance has already been installed) and turn off the mains electrical supply. Remove the wok/pan support, the large burner cap, the burner ring and the large burner cap base. With a cross-slotted screwdriver, loosen the three screws. [. . . ]