User manual RYOBI RPW100S SCHEMA

[. . . ] Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around iron when storing. Always disconnect iron from electrical outlet when filling iron with water, emptying iron or when not in use. [. . . ] Care should be taken to arrange the cord so that it cannot be pulled or tripped over. Steam can only be produced when the thermostat is in the red cotton/ linen zone. Allow iron to heat up (light goes out) before activating the variable steam control. when ironing at low temperatures to avoid water leakage or spitting. min max synthetics (low temperature) silk, wool (medium temperature) cotton, linen (high temperature) min Iron ready for steam ironing Steam is produced as soon as the iron is held horizontally. Steam off Steam generation can be interrupted by standing the iron on its heel or sliding the variable steam control fully to the left. SPRAY SETTING Ensure there is water in the tank. Moistening the fabric with the spray will make wrinkle removal easier. Press the spray button down slowly for a jet or quickly and strongly for a mist. Do not spray silk, etc. 6 BURST OF STEAM To remove stubborn wrinkles or press in a sharp crease, use the burst of steam button. Press the button firmly, a strong burst of steam penetrates deep into the fabric. Leave an interval of at least four seconds between pressing the burst of steam button. With water in the tank, the burst of steam button can be used as soon as the steam ironing temperature has been reached (qqq) Vertical steam The iron can also be used vertically. Do not place the iron on rough surfaces, e. g. metal iron support, which may scratch the soleplate. SELF CLEANING Your iron is equipped with two self clean functions. Do not use descaling agents in your Rowenta iron. 8 Vapodur ® Valve The patented Vapodur ® valve ensures that the opening which allows the water to drip from the water tank into the steam chamber remains unaffected by hard water deposits. To ensure your iron continues to steam efficiently the valve MUST be opened and closed a few times. This is done by moving the variable steam control left to right a few times every time you finish ironing. Steam Chamber Cleaning Function This function allows loose mineral deposits and other impurities that build up inside the iron to be flushed out. This type of self cleaning only needs to be carried out occasionally and never more than once a month. Fill the iron with cold tap water and set variable steam to min. Set thermostat dial to maximum position. When the iron reaches the correct temperature, indicator light will go out, unplug iron. [. . . ] If you experience leaking or spitting, change to untreated tap water or a 50/50 tap/distilled water mix or inexpensive bottled spring water. Allow iron to heat up (indicator light goes out) before using steam control. The light goes on and off showing the thermostat is switching the heat on and off to maintain the correct temperature. Turn variable steam control to a higher setting. [. . . ]