User manual RYOBI RY6202

[. . . ] (140 mm), 14. 4 VOLT CORDLESS CIRCULAR SAW MODEL NO. RY6202 SPECIFICATIONS: Blade Diameter Blade Arbor Cutting Depth at 0° Cutting Depth at 45° No Load Speed Motor Charge Rate Charger Rating 5-1/2 in. (29 mm) 3, 800 RPM 14. 4 Volt DC 1 Hour 120 Volts, 60 Hz, AC Your new cordless circular saw has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. [. . . ] The charger part number will be found on a plate located on the bottom of the charger. Before using the charger, it is extremely important that you familarize yourself with the LED functions of the charger. GREEN LIGHT "ON" INDICATES FULLY CHARGED BATTERY CHARGER LED FUNCTION OF CHARGER See Figure 2. LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK: Red LED lighted = Fast Charging Mode Green LED lighted = Fully Charged Battery Pack Yellow and Green LED Lighted = Control Charge or Defective Battery Pack. YELLOW AND GREEN LIGHTS "ON" INDICATES CONTROL CHARGE OR DEFECTIVE BATTERY PACK RED LIGHT "ON" INDICATES FAST CHARGING MODE Fig. 2 CHARGING BATTERY PACK The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it prior to use. NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (cutting followed by recharging) for them to fully charge. BATTERY CHARGER TO CHARGE Charge battery pack only with the charger provided. Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only. Align raised rib on battery pack with groove in charger. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When properly connected, red light will turn on. Normally, the yellow and green lights on the charger will come on. This indicates charger is in control charge mode and should switch to fast charge mode within 5 minutes. When charger is in fast charge mode the red light will come on. If after a period of 15 minutes the yellow and green lights remain on, remove the battery pack, wait 1 minute and reinsert battery pack in charger. If the yellow and green lights continue to remain on an additional 15 minutes, the battery pack is damaged and will not accept charge. When your battery pack becomes fully charged, the red light will turn off and the green light will turn on. After normal usage, 1 hour of charge time is required to be fully charged. A minimum charge time of 1 to 1-1/2 hours is required to recharge a completely discharged tool. 3 The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem. [. . . ] DO NOT disassemble battery pack and attempt to replace the batteries. Handling of these batteries, especially when wearing rings and jewelry, could result in a serious burn. To obtain the longest possible battery life, we suggest the following: Store and charge your batteries in a cool area. Temperatures above 100° F or below 50° F will shorten battery life. Never store batteries in a discharged condition. [. . . ]