User manual RYOBI RYAN-265

[. . . ] Unused power tools should be stored in a dry, elevated or locked place out of the reach of children. You will work better and safer within the specified power range. If you have accessories for attaching dust suction and collection devices, make sure these are attached and used correctly. Use the correct electric power tool for the job. [. . . ] All parts must be mounted correctly and and work as intended so that the tool operates perfectly. Damaged safety devices and other components must be professionally repaired or replaced by an authorised workshop, unless otherwise indicated in the operating instructions. Damaged switches must be replaced at a customer service workshop. Do not use electric power tools if the ON/OFF switch is not working. wARNING Use only those accessories and add-ons specified in the user manual. The use of other attachments or accessories can be dangerous. Have your electric power tool repair by an electrical specialist. This tool has been manufactured in accordance with current safety regulations. To avoid user accidents, repairs should be carried out only by an electrical specialist using only original replacement parts. wARNING Your reactions can be impaired by alcohol consumption , medication , drugs , illness , fever and tiredness. If any of these conditions applies, do not use electrical power tools!Stationary, precise cutting of wood and wood-product lengths and shapes in a home environment. The tool and accessories (follow manufacturer's instructions) should be used only as intended. Insert the Rear Anti-Tip (28) through the holes on base, then use the pin (a) to fix it (Fig. Pull out saw head lock bolts (8) and guide saw head up to its starting position. press the workpiece firmly against fence (4). Fix both large and small workpieces in position with screw clamp (15). Do not remove workpieces from the bench until the tool has come to a stop. Pull lower guard lock lever (2) and slowly bring saw head to the workpiece. The light from the laser beam allows you to line up precisely the cutting angle and the exact position of the workpiece on the bench. The laser beam can be switched on as required: Press (23) to turn the laser on and press the switch again to turn the laser off. the network cable supplies power to the laser. [. . . ] For transport and storage, lower the saw head and lock it in that position by inserting the safety pin in the hole in the housing. Tip: The dust catcher will be more efficient if you empty the bag frequently. When you finish working, wash out the empty bag with a mild soap solution and leave to dry. That way you'll have all information and parts within easy reach. [. . . ]