User manual RYOBI RYAN-300BV

[. . . ] Avoid body contact with earthed or grounded surface (e. Do not let visitors touch the tool or extension cord. When not it use, tools should be stored in a dry, high or locked up place, out of reach of children Do not force the tool. It will do the job better and safer at the rate for which it was intended. [. . . ] Do not force small tools or attachments to do the job of a heavy duty tool. Do not use tool for purposes not intended. Never carry the tool by the cord or yank it to disconnect it from the socket. Keep the cord away from heat, oil and sharp edges. Keep cutting tools sharp and clean for better and safer performance. Keep handles dry, clean and free from oil and grease Disconnect tools. When not in use, before servicing and when changing accessories such as blades, bits and cutters. Do not carry a plug ged-in tool with a finger on the switch. When tool is used outdoors, use only extension cords intended for outdoor use. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. For continuous operation, press the lock button (E) while squeezing the frigger. Voltage Chuck capacity Drilling capacity in wood in steel in masonry Input No load speed Blows per minute Net weight Safety class II 230 V ~ 50 Hz 13 mm (1/2") 40 mm 13 mm 16 mm 750 W 0 - 2, 800 min-1 0 - 44, 800 min-1 2. To change the rotation direction, stop the tool and push the forward / reverse button (B). When the forward button is pushed in, the bit rotates clockwise when viewed from the handle end of the tool. Then tighten the chuck securely by rotate the chuck head to left hand side. Loosen the handle grip by turning in direction L, and tighten it at an easy to-use position by turning the grip in direction M. Depth stopper By using the depth stopper (G), holes of a fixed depth can be accurately bored. the depth of the hole will be the distance from the end of the bit to the end of the stopper pole. By turning the handle grip in direction L, the stopper pole can be released and the depth adjusted. After adjusting the depth, fix the stopper pole again by turning the handle grip in direction M. [. . . ] After adjusting the depth, fix the stopper pole again by turning the handle grip in direction M. To prevent ugly splits around the drill hole on the reverse side of the workpiece, put a piece of scrap lumber under the work piece. After use, check the tool to make sure that it is in top condition. It is recommended that you take this tool to a RYOBI Authorized Service Center for a thorough cleaning and lubrication at least once a year. [. . . ]