User manual RYOBI SINGER-GT2815-SERIALS502010885-AND-GREATER

[. . . ] Rubber gloves and non-skid footwear are recommended when working outdoors. Wear protecting hair covering to contain long hair. Never carry the tool by the cord or yank it to disconnect it from the socket. Keep the cord away from heat, oil and sharp edges. [. . . ] Check for alignment breakage of parts, mounting and any other conditions that may affect its operation. have defective switches replaced by an authorized service facility. Do not use the tool if the switch cannot turn it on and off. Use only for the purpose listed below: 1. Make sure that the tool is only connected to the voltage marked on the name plate. Never use the tool if its cover or any bolts are missing. If the cover or bolts have been removed, replace them prior to use. Maintain all parts in good working order. Always secure tools when working in elevated positions. Never touch the blade, drill bit, grinding wheel or other moving parts during use. Never start a tool when its rotating component is in contact with the work piece. Put the sanding frame on the belt sander and attach four slot into slot holder (25). By turning the adjustment bolt counterclockwise, the sanding frame will rise and can be taken out. If turning clockwise, it will down and the depth will be added. Push the lever down to the original position (Fig. Ensure that your fingers are not trapped. The belt life will be increased by using the tracking adjustment. Turn the tool upside down and hold if firmly with one hand, then start the tool and observe the tracking of the sanding belt. Stop the tool and adjust the tracking of the belt by rotating the tracking knob until the edge of the belt is even with the outer edges of both the front and rear rollers. Check that the belt does not rub against the tool's frame. Put the belt sander on the sanding frame and attach four slot into slot holder (25). By turning the adjustment bolt counterclockwise, the sanding frame will down and can be taken out. [. . . ] Excessive pressure will retard the abrasive action, leave an uneven finish and cause extra wear to both the tool and the abrasive belt. Always lift the tool off the work piece before turning the switch off. After use, check the tool to make sure that it is in top condition. It is recommended that you take this tool to a Ryobi Authorized Service Centre for a thorough cleaning and lubrication at least once a year. [. . . ]