User manual RYOBI SS180K

[. . . ] OPERATOR'S MANUAL SPEED SAWTM SS180 THANK YOU FOR BUYING A RYOBI SPEED SAW. Your new Speed Saw has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. CAUTION: Carefully read through this entire operator's manual before using your new Speed Saw. [. . . ] (3. 2 mm) 26, 000 RPM 120 VOLTS, 60 HZ, AC ONLY 1 hour UNPACKING INSTRUCTIONS Your Speed Saw has been shipped completely assembled. Carefully remove the Speed Saw and accessories from the box. Make sure that all items listed in the packing list are included. Inspect the Speed Saw carefully to make sure no breakage or damage has occurred during shipping. Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool. PACKING LIST Speed Saw with Depth Adjustment Ring Case Bits (2) Collet Collet Adaptor Circle Cutter Battery Pack Battery Charger Wrench Operator's Manual WARNING: If any parts are missing, do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury. APPLICATIONS With the proper bit, you may use your Speed Saw for the purposes listed below: Cutting electrical outlet openings in drywall or wood paneling. NOTE: Most of these applications require different types of bits. Be sure to use the right-sized bit for your tool. DANGER: Do not cut electrical outlet openings with live electrical wires. Do not cut walls that may have live electrical wiring behind them. Shut off breakers or remove fuses to disconnect the circuit. Always hold the tool by its motor housing. 7 FEATURES SWITCH Your Speed Saw has a conveniently located slide switch. CIRCLE CUTTER The circle cutter enables you to quickly cut circles from 3. 5 in. (30. 5 cm) in diameter. SPINDLE LOCK A spindle lock secures the spindle and allows you to easily loosen the collet nut and change bits. NOTE: Do not run Speed Saw with spindle lock engaged. ERGONOMIC DESIGN The design of your Speed Saw provides for easy handling and maintaining proper control when cutting. It has been designed to be comfortable and easy to grasp when operating in different positions or at different angles. DEPTH ADJUSTMENT RING Your Speed Saw is equipped with a depth adjustment ring that allows you to adjust the depth of cut up to 1 in. (2. 5 cm). BATTERY PACK DEPTH ADJUSTMENT RING SPINDLE LOCK COLLET NUT BIT ADJUSTING KNOB SWITCH Fig. 1 WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. 8 ADJUSTMENTS WARNING: Your Speed Saw should never be connected to power supply when you are assembling parts, making adjustments, cleaning, performing maintenance, or when not in use. Disconnecting your Speed Saw will prevent accidental starting that could cause serious injury. TO TIGHTEN TO LOOSEN INSERTING/REMOVING BITS See Figure 2. Follow these directions when inserting and removing bits. REMOVE BATTERY PACK FROM SPEED SAW. Fig. [. . . ] When your battery pack becomes fully charged, the red light will turn off and the green light will turn on. NOTE: Normally, the yellow and green lights on the charger will come on. This indicates charger is in control charge mode and should switch to fast charge mode within 5 minutes. When charger is in fast charge mode the red light will come on. [. . . ]