User manual RYOBI STP-1201

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. Select the speed when the power tool is at a stand-still. Selector switch for clockwise and anti clockwise rotation Select the direction of rotation when the power tool is at a stand-still. The speed depends on the amount of pressure exerted on the switch. [. . . ] Drill/Driver Motor Chuck Capacity Drilling Capacity (in steel/wood) No load speed (low/high) (rpm) Torque Net Weight Impact Drill/Driver Motor Chuck Capacity Drilling Capacity (in steel/wood) (in concrete) No load speed (low/high) (rpm) Impacts per minute Torque Net Weight ST-1200 ST-1201 700 10mm 10mm/20mm 300/0-1000 min-1 24Nm 2. CE DÉCLARATION DE CONFORMITÉ Nous déclarons sous notre propre responsabilité que ce produit est en conformité avec les normes ou documents normalisés suivants : 89/336/EEC, 73/23/EEC, 98/37/EEC, EN50144, EN292, EN55014, EN60335 CE DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. It is essential that you read the instructions in this manual before mounting and operating this machine. (a) Yellow light (b) Red light (c) Green light 2 Battery charging interface Slide in battery Before using this device, read and comply with these operating instructions and the relevant national industrial safety regulations. These operating instructions should be kept for later use and enclosed with the device when lending it on or selling it. Risk of injury When using the battery charger, the following basic safety precautions must be observed for protection against electric shock, injuries and burns. Please read and observe these instructions before using the device. Before using the device, check that the mains cable and mains plug are not damaged. The device must not be damp, neither should it be used in a damp environment. Do not use the device if it has suffered any heavy shock or jolting, or is damaged in any other way. Due to the heat generated during charging, the battery charger must not be operated on a combustible surface/in an inflammable environment. Unplug the battery charger when it is not in use or when cleaning it. Only use certified extension cables that are in perfect condition. during operation , provide sufficient ventilation. Excessive storage or operating temperatures can cause charger malfunctions during charging. Battery charging in closed cupboards, near heat sources (radiators, bright sunshine) etc. Causes heat to accumulate and can damage the device. If the battery is not going to be used for a long period of time, remove the battery from the battery charger and unplug the charger. Protect battery terminals to avoid short circuits which may be caused by metallic objects. These short circuits could cause a fire or an explosion! [. . . ] It will work best at normal room temperature. When moving the charger suddenly from a low temperature location to high temperature location, check whether moisture has formed on the unit. If moisture has formed, allow the charger to sit for 1 to 2 hours with the plug disconnected from the outlet before using it. Display Of Charging Lights Steady Green Light Steady Red Light Flashing Red Light Finished Charging While Charging Temperature of battery is too high Battery pack is very run down Charging is impossible · Before cleaning, pull out the mains plug. [. . . ]