User manual RYOBI TFD220I SCHEMA ELECTRIC

[. . . ] 14 Cleaning the exterior and the control panel . 15 Emptying the condensed water container . 35 2 IMPORTANT SAFETY INSTRUCTIONS , WARNING - To reduce the risk of ~ To prevent the risk of fire, the following textiles must not be dried in this dryer: ­ items which have not been washed. ­ items, such as work-wear, exposed to grease, oils, or other deposits (such as lotions or cosmetics) in your dryer. [. . . ] Lock the door frame filters. ^ The exterior and the control panel can be cleaned with warm water and liquid dish soap applied with a soft sponge. ^ Wipe dry. Cleaning the drum ^ The stainless steel surfaces of the drum can be cleaned using a non-abrasive stainless steel cleaner. ^ Wipe clean with a soft cloth. 15 Dryer care Emptying the condensed water container Depending on the installation, the condensed water will either be pumped to a drain or collected in the condensed water container, located in the upper left corner of the machine. The container holds approximately 1 gallon of water. Should the container be full when the tumble dryer is started, or if it becomes full during normal operation: ­ The "Container" indicator will light. ^ Pull out the container slightly to the right with both hands. ^ Hold the cap open while emptying the container. ^ When the container is empty, push it back into its opening until it clicks into place. Do not drink the condensed water! 16 Dryer care Cleaning the condenser , To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. ^ Clean the condenser every 6 months and when the "Filter/Vent" indicator lights. Clean approximately every 100 uses when the dryer is used often. ^ Turn the condenser door lock down and remove the door up and out. Removing the condenser The access panel to the condenser is located on the lower left corner of the dryer. ^ Turn the condenser lock up. ^ Open the access panel with the supplied yellow tool. ^ Remove the panel up and out of the condenser access area. ^ Pull out the condenser. 17 Dryer care Rinsing the condenser Returning the Condenser ^ Put the condenser back in place in the reverse order. Check that the gasket around the front of the condenser is flush and not crimped. Allow items to air dry. Smooth Sturdy Fluff - TIMED CYCLES 20 min 45 min Available drying options Gentle, Anti-crease - Quick Guide Changing the light bulb ^ Replace the light bulb with a temperature proof bulb, available from Miele. The light bulb must not exceed the maximum wattage listed on the data plate. ^ Flip up the light bulb cover and press it firmly until it clicks into place. , To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. ^ Open the door. The bulb cover is located along the upper rim of the drum opening. , Make sure the bulb cover is ^ Restore power. securely closed to prevent a short circuit or penetrating moisture. ^ Slide a screwdriver with a wide head underneath the side edge of the bulb cover and twist (see illustration). ^ Flip down the bulb cover. 19 Frequently asked questions What if the dryer will not run?Possible fault The "Start/Stop" button was not pressed. The circuit breaker tripped or the dryer is unplugged. Add fabric softener to laundry when washing or select the "Less Dry" setting on the dryer. Do not use fabric softener sheets in this dryer. What if the drum light does not come on?Possible fault The bulb may be bad or burned out. [. . . ] Otherwise drying times and energy usage may increase. ^ The machine can be leveled by turning the legs clockwise or counterclockwise as necessary. 30 Installation External water drain When drying is in progress, condensed water is pumped into the condensed water container through the drain hose at the back of the dryer. The condensed water can also be drained directly if the machine is installed near a sink or a standpipe so that the condensed water container does not have to be emptied. 4' 11" (1. 5 m) Maximum delivery head . [. . . ]