User manual RYOBI TFI180I SCHEMA ELECTRIC

[. . . ] 14 Cleaning the exterior and the control panel . 15 Emptying the condensed water container . 32 2 IMPORTANT SAFETY INSTRUCTIONS , WARNING - To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: ~ Do not repair or replace any part of the appliance or attempt any servicing unless specifically recommended in these operating instructions. Repairs to electrical appliances should only be performed by qualified personnel. [. . . ] Particles from the cool air sucked in from the install location can cause blockages. ^ Check the condenser at least twice a year. ^ Clean if necessary. ^ Open the access panel, located on the lower left corner of the machine, using the yellow tool supplied with the machine. Hold the panel when opening it. ^ Remove the panel up and out of the condenser access area. ^ Turn the condenser door lock down and remove the door. 17 Dryer care Checking the condenser ^ Hold the condenser against the light. ^ Turn the condenser lock up. ^ Look through the front and left side (as illustrated above) of the condenser to check for lint. If no lint is visible: ^ Return the condenser. If lint is visible: ^ Clean the condenser as described. ^ Pull out the condenser. 18 Dryer care Cleaning the condenser ^ Rinse the condenser along all sides with warm water as shown in pictures below. Returning the condenser ^ Put the condenser back in place in the reverse order. Check the gasket around the front of the condenser is flush and not crimped. ^ To prevent leaks, make certain the condenser is pushed in all the way and locked in place. Program for reducing creasing in delicate items. Individual items to be freshened and fluffed with cool air. Individual items or very small loads, e. g. Take items out immediately after the end of the program while still slightly damp. Allow items to air dry. Smooth Sturdy Fluff - TIMED CYCLES 20 min 45 min Available drying options Gentle, Anti-crease - Frequently asked questions What if the dryer will not run?Possible fault The "Start/Stop" button was not pressed. The circuit breaker tripped or the dryer is unplugged. Add fabric softener to laundry when washing or select the "Less Dry" setting on the dryer. Do not use fabric softener sheets in this dryer. What if the drum light does not come on?Possible fault The bulb may be bad or burned out. [. . . ] The warm air exhausting from the dryer will affect the thermostat of the refrigerator, causing it to run continuously. Level the dryer ^ The dryer must be level to ensure safe and proper operation. ^ The machine can be leveled by turning the legs clockwise or counterclockwise as necessary. 32 Installation Installing the decor panel The door can be fitted with a customized door panel (optional accessory) to match the adjacent cabinets. 1/16" - 3/16" (1. 6 - 4. 8 mm) ^ Open the door. ^ A decor panel up to 3/16" thickness can be inserted if the frame sides are pushed forward. ^ Press the frame sides onto the panel und tighten the screws. [. . . ]