User manual RYOBI TS230

[. . . ] (254 mm) Compound Miter Saw Model TS230 - Double Insulated DANGER HANDS AWAY KEEP FROM BLADE 45 45 30 15 0 0 20 10 THANK YOU FOR BUYING A RYOBI COMPOUND MITER SAW. Your new saw has been engineered and manufactured to Ryobi's high standards for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. CAUTION: Carefully read through this entire operator's manual before using your new saw. [. . . ] To install the work clamp, place the shaft of the clamp in either hole in front of the miter table base. Thread the 8 mm work clamp screw provided into the side of the base and tighten it to secure the clamp in position. Rotate the knob on the clamp to move the it in or out as needed. 45 45 30 15 0 WARNING: When using the work clamp with the stop block, install the clamp on the stop block side of the blade. This will eliminate the possibility of the saw catching the loose end and kicking up. Failure to heed this warning can result in serious personal injury. 0 20 10 WORK CLAMP 8 mm WORK CLAMP SCREW UPPER BLADE GUARD MITER TABLE BASE Fig. 8 DUST GUIDE INS DUST GUIDE See Figure 9. To install the dust guide, place the end marked INSERT over the exhaust port in the upper blade guard. Turn the guide so that the open end is facing down. EXHAUST PORT WARNING: A 10 in. (254 mm) blade is the maximum blade capacity of your saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade screw from securing the blade on the spindle. Either of these situations could result in a serious accident and can cause serious personal injury. 20 TO INSTALL BLADE See Figures 10, 11, and 12. s Unplug your saw. Page 12 10 20 30 40 45 0 10 20 30 40 45 10 0 Fig. 9 ASSEMBLY WARNING: Failure to unplug your saw could result in accidental starting causing possible serious personal injury. s Push down on the saw arm and pull out the lock pin to release saw arm. Raise saw arm to its full raised position. Be cautious, saw arm is spring loaded to raise. Gently raise the lower blade guard bracket, releasing lower blade guard from notch so that it can be rotated up. Loosen the phillips screw on the blade bolt cover until blade bolt cover can be raised. Rotate the lower blade guard and blade bolt cover up and back to expose the blade bolt. Depress the spindle lock button and rotate the blade bolt until the spindle locks. Using the blade wrench provided, loosen and remove the blade bolt. [. . . ] Do not overtighten. BRUSH ASSEMBLY 10 0 45 Fig. 34 s s s s s Page 26 TROUBLESHOOTING PROBLEM Saw will not start. CAUSE 1. Have switch replaced by Ryobi Factory or Authorized Service Center. Have cord replaced by Ryobi Factory or Authorized Service Center. [. . . ]