User manual RYOBI TURF-POWER-720TP

[. . . ] Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment breakage of parts, mounting and any other conditions that may affect its operation. A guard or other parts that is damaged should be properly repaired or replaced by an authorized service centre 6 Unless otherwise indicated in this instruction manual. have defective switches replaced by an authorized service facility. [. . . ] Do not charge batteries of other manufactures. When drilling or screwing in walls, they must be checked for hidden electric cables or water and gas pipes with a detector. Do not work with materials containing asbestos!Do not drill holes into the housing to label the machine. Protect the cables of the battery charger from sharps edges. Damaged cables must be replaced immediately by one of our service depots. For safety reasons, work only with the auxiliary handle mounted. Wear protective glasses, hearing protection, protective gloves and steady shoes. when the drill unexpectedly jams , the machine kicks back. Therefore, always take a secure stand and hold the machine firmly with both hands. Chuck Accessories illustrated or described are not always included as standard delivery items. With the On/Off switch, the speed can be continuously varied. With light pressure on the On/Off switch, the machine begins to rotate slowly; with increased pressure, the speed increases. Make sure the charging points provide good contact. Should charging still not be possible, please send the battery and battery charger to the nearest RYOBI service centre. To obtain the maximum service life, do not recharge the battery immediately after a short period of use but, if possible, discharge to the lower capacity limit and then recharge. Only use the machine together with the auxiliary handle. Place the auxiliary handle onto the clamping collar and tighten firmly with the handle piece. For metal, use only flawless, sharpened drills; for stone and concrete, only masonry drills with hard metal inserts. Always adapt the speed to the material to be worked and the diameter of the drill. For precision working with metal and wood, place the machine in a drill stand (accessory). Wear protective glasses and hearing protection. [. . . ] Do not drill hidden electrical lines or gas and water pipes. Check the area to worked with a metal detector, for example, before starting. Se till att ingenting täpper till öppningarna i laddaren. Ännu bättre är att ansluta batteriet till laddaren: denna övergår automatiskt till serviceläge då batteriet är helt urladdat. [. . . ]