User manual RYOBI TURF-POWER-780TP

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. damaged or entangled cords increase the risk of electric shock. When operating a power tool outdoors, use an extension cord suitable for outdoor use. [. . . ] Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. Do not use the power tool if the switch does not turn it on and off. Any power tool that can not be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. Check for misalignment or bindling of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. This will ensure that the safety of the power tool is maintained. Align the raised rib battery pack with the groove inside the drill. Make sure the latches on each side of the battery pack snap into place and the battery pack is secured in drill the before beginning operation. CAUTION When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Voltage Staple speed Battery pack (Not Included) Charger (Not Included) 18 V 40 shots/min BPP-1817M / BPP-181M BC-1815S / BC-1800 Locate the latches on the side of the battery pack and depress to release the battery pack from the drill. Place staples in channel, legs facing upward and close base. Make sure the tabs are securely locked in place. Remove jammed brad/staple with needle nose pliers. Note: You must remove jammed brad/staple before using tool any further. If you try to fire a brad/staple while the tool is jammed, you could cause damage to the mechanism. Use of any other parts may create a hazard or cause product damage. [. . . ] All other parts should be replaced at a Authorized Service Center. Press the activation foot of the nailer/stapler down against the workpiece to disengage the safety interlock. The activation foot must be depressed before the switch trigger is depressed. Release the trigger switch and activation foot before driving another brad or staple. [. . . ]