User manual RYOBI W660

[. . . ] cluttered and dark areas invite accidents. B) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes. C) Keep children and bystanders away while operating a power tool. [. . . ] Use of any other battery packs may create a risk of injury and fire. D) When battery pack is not in use, keep it away from other metal abjects like paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. shorting the battery terminals together may cause burns or a fire. E) Under abusive conditions, liquid may be ejected from the battery; avoid contact. if contact accidentally occurs , flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns. 6) SERVICE a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 7) SPECIAL RULES a) Wear ear protectors with impact drills. Exposure to noise can cause hearing loss. CHARGING YOUR BATTERY PACK The battery pack for your tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it prior to use. Note: Batteries will not reach full charge the first time they are charged. Allow several cycles for them to fully charge. Keyless chuck Switch trigger Direction of rotation selector (Forward/Reverse) Screwdriver bits Battery pack Battery indicator Latches Depress latches to release battery pack Auxiliary Handle(For W660/1442/1802) To Tighten To Loosen Drill bit Depth Gauge Rod(For W660/1442/1802) Drilling Depth To Decrease torque To Increase torque Torque adjusting Ring Drill mode Impact mode (For W660/1442/1802) Reverse Forward 9 Charge battery pack only with the charger provided. Make sure power supply is normal house voltage, 230 volts, 50 Hz, AC only. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When properly connected, red light will turn on. When your battery pack becomes fully charged, the red light will turn off and the green light will turn on. After normal usage, 1 hour of charge time is required to be fully charged. A minimum charge time of 1 to 1-1/2 hours is required to recharge a completely discharged tool. [. . . ] To stop, release switch trigger and allow the chuck to come to a complete stop. Lock the trigger switch by placing the rotation selector in the center position. When the trigger switch is released, the chuck stops turning. When the brake is functioning properly, sparks will be visible through the vent slots on the housing. [. . . ]