User manual SABINE PHANTOM MIC RIDER PMR-GP1

[. . . ] PMR-GP1 Operating Guide Table of Contents Introduction Features Installation - GP1 Installation - HH1 Operation Tips & Troubleshooting Chart of Mic Sensitivities Specifications Warranty PMR-HH1 3 5 6 12 14 21 23 25 26 The Phantom Mic Rider is designed to work with industry standard (DIN & IEC) phantom power sources. For more information see Specifications on page 25 of this operating guide. MADE IN USA PATENT PENDING 2 Congratulations on getting your new Phantom Mic Rider!This operating guide covers the use of both models of the Phantom. Follow the directions that apply to your model. [. . . ] Using the Phantom Tool press the SEN button momentarily and you will see the red LED flash. Factory default setting (#2) is indicated by two quick flashes. Refer to the Microphone Sensitivity chart on page 23 of this Operating Guide to find your microphone's specification for sensitivity and make a note of the Phantom setting for your mic. Press the SEN button again and you can cycle through the three settings: Setting #1 (Low), #2 (Medium), and #3 (High). When you arrive at your desired setting simply wait and that setting will become active when the LED stops flashing and turns to green. You can verify your setting by repeating Step 2. 15 Operating the PhantomTM FBX Setup GP+HH This procedure will set the FBX Feedback Exterminator filters and will increase your gain before feedback. These FBX filters are all fixed filters - once Ready Mode is engaged they are fixed in their location, width, and depth. They are no longer adaptive, and there are no dynamic filters available with the Phantom. These are not necessary because your podium mic should not be moving during the program!The Phantom will provide between two and four FBX filters depending on system acoustics. Make sure the Phantom is installed as described in "Installing the Phantom" previously. Do not talk into the mic during this setup procedure. Turn down the gain for this mic and mute all other mics on your mixer. Using the Phantom Tool press and hold the FBX button for three seconds. The amber LED will flash continuously when you have held it long enough. Slowly raise the gain for this mic until you hear the first feedback tone. You will hear a pulsing sound moments before the feedback filters are set - this helps indicate the FBX 16 GP+HH Operating the PhantomTM FBX Setup (continued) is in setup mode. The Phantom's first FBX filter will engage and remove the tone. The flash rate of the LED increases with every filter that is placed. Raise the gain again until you hear another feedback tone. The Phantom's second FBX filter will engage. Continue raising gain until the amber LED turns green and the pulsing stops. [. . . ] The product has been damaged by accident or unreasonable use, neglect, improper service or maintenance, or other causes not arising out of defects in material or workmanship; or d. The serial number affixed to the product is altered, defaced or removed; or e. The power supply grounding pin is removed or otherwise defeated. In the event of a defect in material and/or workmanship covered by this limited warranty, Sabine will repair the defect in material or workmanship or replace the product, at Sabine's option; and provided, however, that, in any case, all costs of shipping, if necessary, are paid by you, the purchaser. [. . . ]